Unveiling 3D sub-grain residual stresses in as-built additively manufactured steel using scanning 3DXRD
Authors:
Open Access
- 11 May 2025
- journal article
- Published by Taylor & Francis in Materials Research Letters
- Vol. 13 (7) , 700-708
Abstract
No abstract availableFunding Information
- National Science Foundation (DMR- 2237433)
- The Michigan Center for Materials Characterization
This publication has 30 references indexed in Scilit:
- Delineating dislocation structures and residual stresses in additively manufactured alloysActa Materialia, 2023
- Defects and anomalies in powder bed fusion metal additive manufacturingCurrent Opinion in Solid State and Materials Science, 2022
- Residual stress analysis of in situ surface layer heating effects on laser powder bed fusion of 316L stainless steelAdditive Manufacturing, 2021
- Evaluating the grain-scale deformation behavior of a single-phase FCC high entropy alloy using synchrotron high energy diffraction microscopyActa Materialia, 2021
- Part scale estimation of residual stress development in laser powder bed fusion additive manufacturing of Inconel 718Finite Elements in Analysis and Design, 2021
- AFRL Additive Manufacturing Modeling Series: Challenge 4, 3D Reconstruction of an IN625 High-Energy Diffraction Microscopy Sample Using Multi-modal Serial SectioningIntegrating Materials and Manufacturing Innovation, 2021
- Characterization of Microstructure in Additively Manufactured 316L using Automated Serial SectioningCurrent Opinion in Solid State and Materials Science, 2020
- Solidification-driven orientation gradients in additively manufactured stainless steelActa Materialia, 2020
- An Experimental Investigation into Additive Manufacturing-Induced Residual Stresses in 316L Stainless SteelMetallurgical and Materials Transactions A, 2014
- Observation of recovery and recrystallization in high-purity aluminum measured with forward modeling analysis of high-energy diffraction microscopyActa Materialia, 2012