Modified rectifications for improving the charge equalisation performance of series‐connected battery stack
Authors:
Open Access
- 1 July 2016
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 9 (9) , 1924-1932
Abstract
Two modified rectifications for improving the charge equalisation performance of series‐connected battery stack are proposed in this study. Not only high reliability can be achieved because only one power switch is required, but also the control circuit is simple due to no voltage sensors. In addition, high efficiency can be achieved because of zero‐voltage‐switching. In this study, two modified rectifications are presented to eliminate the voltage differences between the odd and even batteries, which are not removed by the conventional methods, and reduce the number of transformer windings and diodes. Hence, the cost, size and complexity of the system can be reduced. The circuit topology and operation analysis of the proposed equaliser are described in detail. Finally, the simulations and experimental results are provided to demonstrate the performance of the proposed charge equaliser.Keywords
This publication has 25 references indexed in Scilit:
- Low Power Very High Frequency Switch-Mode Power Supply With 50 V Input and 5 V OutputIEEE Transactions on Power Electronics, 2014
- Center-Cell Concentration Structure of a Cell-to-Cell Balancing Circuit With a Reduced Number of SwitchesIEEE Transactions on Power Electronics, 2014
- Lithium‐ion battery state of charge estimation based on square‐root unscented Kalman filterIET Power Electronics, 2013
- One‐inductor‐based auxiliary circuit for dc‐link capacitor voltage equalisation of diode‐clamped multilevel converterIET Power Electronics, 2013
- Takagi–Sugeno–Kang type probabilistic fuzzy neural network control for grid‐connected LiFePO 4 battery storage systemIET Power Electronics, 2013
- Verification of battery system model for environmentally friendly vehicles using a battery hardware‐in‐the‐loop simulationIET Power Electronics, 2013
- Exact analysis and design of zero voltage switching operation for class E inverter with circuit components varyingIET Power Electronics, 2013
- An approach to measurements of electrical characteristics of lithium-ion battery with open-circuit voltage functionIET Power Electronics, 2012
- Class- E- based charge-equalisation circuit for battery cellsIET Power Electronics, 2012
- Energy gauge for lead-acid batteries in electric vehiclesIEEE Transactions on Energy Conversion, 2000