CHChih-Chiang Hua

Chih-Chiang Hua

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Chih-Chiang Hua has a total of 32 co-authors. Here are the top co-authors by number of shared publications:

  • Yi‐Hsiung Fang

    Graduate School of Engineering Science and Technology National Yunlin University of Science and Technology Douliou Yunlin Taiwan

    7 shared publications
  • Chih‐Wei Chuang

    Graduate School of Engineering Science and Technology National Yunlin University of Science and Technology Douliou Yunlin Taiwan

    2 shared publications
  • Chun-Wei Wu

    Graduate School of Engineering, Science & Technology, National Yunlin University of Science and Technology, Tel: 886-05-5342601-4250, Fax: 886-05-5312042

    2 shared publications
  • Cheng‐Wei Lin

    Department of Electrical Engineering National Yunlin University of Science and Technology Douliou Yunlin Taiwan

    1 shared publication
  • Chien‐Hsing Li

    Power Electrics and Sustainable Energy Center (PESEC), Department of Electrical Engineering , National Yunlin University of Science and Technology , Douliou, Yunlin, Taiwan, R.O.C. Phone: 886–5–5342601 ext. 2827 Fax: 886–5–5342601 ext. 2827

    1 shared publication
  • Chih-Wei Chuang

    Graduate School of Engineering Science & Technology National Yunlin University of Science and Technology, 123 University Road Section 3, 640 Douliu, Yunlin, Taiwan

    1 shared publication

Latest Publications

  • Open Access

    A Parallel Dual LLC Resonant Converter with Wide Output Voltage Range for Energy System Applications

    by Chih-Chiang Hua, Jian-Bin Lai, Wei-Cheng Hung

    This paper proposes a half-bridge parallel dual LLC resonant converter with wide output voltage range. The proposed converter uses a conventional parallel double half-bridge LLC resonant converter. On the primary side of the converter, only one of the two half bridges is used to control the two resonant loops. Due to the resonance of the converter, the active switches can achieve ZVS (zero-voltage switching), and the rectifier diode can also achieve ZCS (zero-current switching), and thus the switching loss is reduced. The current stress can be reduced and power can be distributed on both of the primary side and/or the secondary side. A voltage regulation circuit is designed on the secondary side to achieve the function of wide output voltage. The operation and analysis of the proposed converter are described in detail. The experiments were carried out on a circuit prototype, which is a converter with DC input voltage of 384 V and output voltage of 24–40 V and operating at a switching frequency of 107 kHz. The feasibility and performance of the proposed converter were verified by simulation and experimental results.


  • Open Access

    A Bidirectional Isolated DC-to-DC Converter with Hybrid Control of Pulse Width Modulation and Pulse Frequency Modulation

    by Chih-Chiang Hua, Jian-Bin Lai

    This paper proposes a modified bidirectional isolated DC/DC converter with hybrid control, which can be applied to bidirectional power transfer between energy storage systems and DC microgrids. Batteries are usually applied to energy storage systems. The battery lifespan may be shortened if the converter has large current ripple during the battery charging process. The proposed topology consists of a CLLC converter and an interleaved buck converter. The first stage is an isolated full bridge CLLC converter, and the second stage is an interleaved buck converter with hybrid control of pulse width modulation (PWM) and pulse frequency modulation (PFM). Additionally, the proposed topology achieves zero voltage switching (ZVS) for all switches and reduces the output current ripple. The operational principles of bidirectional power flow in both directions are described in detail. Finally, a 1.5 kW experimental prototype, rated with a high side voltage of 380 V and low side voltage range of 40–58 V, was constructed and tested to investigate the system performance. The measured highest efficiency for the proposed converter is 90% in charging mode, and 94% in discharging mode.


  • Open Access

    A Hybrid Maximum Power Point Tracking Method without Oscillations in Steady-State for Photovoltaic Energy Systems

    by Chih-Chiang Hua, Yu-Jun Zhan

    This paper proposes a hybrid maximum power point tracking (MPPT) method with zero oscillation in steady-state by combining genetic algorithm (GA) and perturbation and observation (P&O) method. The proposed MPPT can track the global maximum power point (GMPP) fast for a photovoltaic (PV) system even under partial shaded conditions (PSC). The oscillations around the GMPP are eliminated and the power loss can be reduced significantly. In addition, the proposed MPPT can make the PV system operate at the highest efficiencies under various atmospheric conditions. During the MPP tracking, the system will oscillate around the MPPs, resulting in unnecessary power loss. To solve the problem, the artificial intelligence (AI) algorithms, such as PSO, Bee Colony optimization, GA, etc., were developed to deal with this issue. However, the problem with the AI algorithm is that the time for convergence may be too long if the range of the MPP search space is large. In addition, if the atmospheric conditions change fast, the PV system may operate at or close to the local maximum power points (LMPPs) for a long time. In this paper, a method combining the P&O’s fast tracking and GA’s GMPP tracking ability is proposed. The proposed system can stop the oscillations as soon as the GMPP is found, thus minimizing the power loss due to oscillations. The proposed MPPT can achieve superior performance while maintaining the simplicity of implementation. Finally, the simulation and experimental results are presented to demonstrate the feasibility of the proposed system.


  • Open Access

    Modeling a Dual-Mode Controller Design for a Quasi-Resonant Flyback Converter

    by Ching-Chun Chuang, Chih-Chiang Hua, Chong-Yu Huang, Li-Kai Jhou

    The proposed system can overcome the disadvantage of a high peak current in quasi-resonant fly-back (QRF) converters when operated under heavy load conditions. The operating mode and control scheme of a QRF converter with dual-mode control were established and analyzed. The dual-mode control scheme not only enabled a valley-switching detection technique that satisfied the zero-voltage switching condition but also provided a constant frequency mechanism to reduce the conduction loss in QRF converters when operated in a continuous conduction mode and under heavy load conditions. The small-signal equivalent circuit model of QRF converter circuits was constructed using an average approximation method. The technological advancement of a QRF converter with a dual-mode controller was presented in this study. The circuit simulation result of the proposed QRF converter with a mix control scheme proved that the derived circuit component parameters meet the requirements of the converter.


  • An Interleaved Flyback-Typed LED Driver With ZVS and Energy Recovery of Leakage Inductance

    by Hung-Liang Cheng, Yong-Nong Chang, Hau-Chen Yen, Chih-Chiang Hua, Pei-Shuo Su

    Flyback converter has advantages of simple circuit configuration and easy control. However, it suffers two problems. One is the active switch is hard switching. The other is a very high voltage spike when the active switch is turned off. In order to solve these problems, this paper presents a novel dc-to-dc converter that mainly consists of two interleaved flyback converters. Both active switches can achieve zero-voltage switching on (ZVS) without the use of any active clamp circuit or snubber circuit. In addition, the leakage flux energy can be delivered to the output by using two added diodes. It helps to reduce the voltage spikes on the active switches and improve circuit efficiency. The steady-state analyses at different operation modes and the mathematical equations for parameters design are provided. Finally, a 200-W prototype circuit for driving high-brightness light-emitting diodes (LEDs) is built and tested to verify the feasibility of the proposed circuit. The LEDs are dimmed form 100% to 10% full power. Satisfactory performances are obtained from the experimental results.


  • Open Access

    Improved solar system with maximum power point tracking

    by Chih‐Chiang Hua, Yi‐Hsiung Fang, Cyuan‐Jyun Wong

    This study presents an improved solar system with maximum power point tracking (MPPT). A digital signal processor is used to control the converter with the proposed control; thus, the system can implement MPPT independently for each solar panel whether it is under shading, various irradiation conditions or with faulty solar cells. A modified MPPT method is designed to reduce the power oscillation significantly, thus the power loss is reduced. With the proposed scheme, most of the solar panel available output power is delivered to the load only through a diode, reducing the converter power loss. In addition, the converter only handles part of the solar panel output power. Therefore, the system cost is reduced due to the low‐power rating converter. A laboratory prototype is constructed and tested to evaluate the effectiveness of the proposed system. The proposed photovoltaic (PV) system and the PV balancer are compared through simulations and experiments under various shading conditions. The experimental results show that the proposed PV system can produce more output power with high efficiency.


  • Open Access

    LLC resonant converter for electric vehicle battery chargers

    by Chih‐Chiang Hua, Yi‐Hsiung Fang, Cheng‐Wei Lin

    This study presents a new LLC resonant converter with two transformers in parallel for the electric vehicle battery charger. This topology achieves the zero‐voltage switching for main switches in the entire charging profile. In addition, the zero‐current switching for output rectifier diodes is extended under charging condition. The proposed charger provides a wide range output voltage for the battery system. Moreover, in order to maintain the high efficiency under charging, the charger adopts a bidirectional switch. At low‐output power condition, the charger uses one transformer to transfer the energy. Finally, the design procedure is provided and implemented in a prototype charger with the input DC link 400 V and the output voltage of 36–58 V. Experimental results are presented to demonstrate the system performance. The maximum power is up to 700 W and the peak efficiency is as high as 93.6%.


  • Open Access

    Modified rectifications for improving the charge equalisation performance of series‐connected battery stack

    by Chih‐Chiang Hua, Yi‐Hsiung Fang, Yen‐Liang Chen

    Two modified rectifications for improving the charge equalisation performance of series‐connected battery stack are proposed in this study. Not only high reliability can be achieved because only one power switch is required, but also the control circuit is simple due to no voltage sensors. In addition, high efficiency can be achieved because of zero‐voltage‐switching. In this study, two modified rectifications are presented to eliminate the voltage differences between the odd and even batteries, which are not removed by the conventional methods, and reduce the number of transformer windings and diodes. Hence, the cost, size and complexity of the system can be reduced. The circuit topology and operation analysis of the proposed equaliser are described in detail. Finally, the simulations and experimental results are provided to demonstrate the performance of the proposed charge equaliser.


  • Open Access

    Low‐cost switched capacitor charge equaliser with cancellation mechanism of alternating current

    by Chih‐Chiang Hua, Chih‐Wei Chuang, Yi‐Hsiung Fang

    A low‐cost switched capacitor charge equaliser with cancellation mechanism of alternating current for electric vehicles is proposed in this study. Among various charge equalisers, the switched capacitor type equaliser is popular due to its simplicity, small volume and low cost. However, the cycle life of battery will be reduced by unnecessary energy transfer since an alternating current flows through the battery without energy change. Hence, a cancellation mechanism of alternating current is presented to deliver energy directly from the source battery to the target battery, which avoids the unnecessary charging and discharging for the battery without energy variations. A low‐voltage H‐bridge drive integrated circuit (IC) is used to reduce the cost, size and complexity of the proposed equaliser. The circuit topology and operation analysis of the proposed charge equaliser are described in detail. Finally, the experimental results verify the effectiveness and performance of the proposed charge equaliser.


  • Open Access

    Zero‐voltage‐transition bridgeless power factor correction rectifier with soft‐switched auxiliary circuit

    by Chih‐Chiang Hua, Yi‐Hsiung Fang, Chin‐Hsiung Huang

    This study presents a zero‐voltage‐transition (ZVT) bridgeless power factor correction (PFC) rectifier, which uses an auxiliary circuit with a transformer to achieve soft‐switching for the main power switches. With the auxiliary circuit, the main switches can be ZVT turned‐on without any additional voltage or current stresses. In addition, the auxiliary switch is turned‐off with zero‐current switching. Therefore, the switching loss of all power switches is reduced, and the overall rectifier efficiency is improved. The circuit topology, operation analysis and the components selection of the proposed rectifier are described in detail. Finally, a laboratory prototype of 700 W is implemented and tested to verify the performance of the proposed PFC rectifier.