Development of a Portable Multimetric Sensing System for Bridge Load Testing and Load-Carrying Capacity Evaluation
Preprint
- 7 February 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
—Regular evaluation of bridge load-carrying capacity relies on static and dynamic load tests that measure vibration, strain, displacement, and neutral axis response. Conventional wired instrumentation is accurate but bulky, power demanding, and time consuming to deploy, which limits field efficiency and rapid verification of sensor quality. This study presents a portable, low-power multimetric measurement system that simultaneously acquires three-axis acceleration and four-channel strain and estimates displacement via multimetric data fusion. The hardware integrates a 24-bit ADC, a MEMS accelerometer, an RTC, on-board microSD storage, and Bluetooth Low Energy communication in a single module, while embedded firmware enables synchronized acquisition at 1000 Hz with filtering and downsampling. A mobile application provides trigger-based recording, real-time signal visualization, and broadcast time synchronization across multiple nodes without a base station. Laboratory tests show low noise levels (0.48 mg acceleration and 0.69 με strain) and multi-node timing differences within 0.05 s. Field validation was conducted on an in-service steel box girder bridge using a 15-ton truck for static load cases and dynamic passes at 10–70 km/h. Displacement estimated from synchronized strain and acceleration agreed with a co-located LVDT, with a maximum error below 0.1 mm. These results demonstrate that the proposed system enables efficient bridge load testing by providing synchronized multimetric measurements and on-site data quality assurance, supporting practical load-carrying capacity evaluation under field conditions while reducing effort and minimizing cabling-related signal degradation.Keywords
This publication has 21 references indexed in Scilit:
- Digital Twin Construction in Practice: A Case Study of Closed-Loop Production Control Integrating BIM, GIS, and IoT SensorsJournal of Construction Engineering and Management, 2025
- Monitoring displacement, strain, and acceleration of a steel railway bridgeAin Shams Engineering Journal, 2023
- Bridge Load Testing: State-of-the-PracticeJournal of Bridge Engineering, 2021
- Recent advances and trends in structural health monitoring2019
- Next Generation Wireless Smart Sensors Toward Sustainable Civil InfrastructureProcedia Engineering, 2017
- Life-Cycle Performance of Deteriorating Structural Systems under Uncertainty: ReviewJournal of Structural Engineering, 2016
- Displacement Estimation Using Multimetric Data FusionIEEE/ASME Transactions on Mechatronics, 2013
- Bridge Rating Using System Reliability Assessment. I: Assessment and Verification by Load TestingJournal of Bridge Engineering, 2011
- Reliability-Based Life-Cycle Management of Highway BridgesJournal of Computing in Civil Engineering, 2001
- Dynamic Tests and System Identification of BridgesJournal of the Structural Division, 1982