A Study of Scandia-Doped-Impregnated Cathode Fabricated by Spray Drying Method
Authors:
- 24 March 2015
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 62 (5) , 1635-1640
Abstract
Scandia-doped-impregnated (SDI) cathodes were fabricated with scandia-doped tungsten powders using spray drying (SD) combined with two-step reduction in hydrogen atmosphere. The temperature-programmed reduction results show that the addition of Sc 2 O 3 leads to a decrease of the reduction temperature of scandia-doped tungsten oxide powders. Using the obtained scandia-doped tungsten powders with homogenous distribution of nanosized scandia, a submicrometer porous matrix cathode composed of tungsten grains with active substances distributing uniformly around these grains has been obtained. For cathodes with the above matrices and impregnated with 411 or 612 Ba, Ca aluminates (named SDI/SD-411 or SDI/SD612 cathodes, respectively) and space charge limited current densities of ~72.5 A/cm 2 have been reliably reached at 900 °Cb. After proper activation, the cathode surface is covered by a Ba-Sc-O active substance layer with preferable atomic ratios, leading to its good emission property. The average evaporation rate of 8.45 × 10 -9 gcm -2 s -1 at 1150 °Cb for SDI/SD-612 cathode is the lowest one among Ba-W, W/Re/Os-M, SG-411 (the scandia-doped cathode fabricated by sol-gel method with impregnating 411 aluminates), and SDI/SD-612 cathodes.Keywords
Funding Information
- National Natural Science Foundation of China (51471006, 51225402)
This publication has 22 references indexed in Scilit:
- DC Emission Characteristic of Nanosized-Scandia-Doped Impregnated Dispenser CathodesIEEE Transactions on Electron Devices, 2014
- Scandate Dispenser Cathodes With Sharp Transition and Their Application in Microwave TubesIEEE Transactions on Electron Devices, 2014
- A novel approach to synthesis of scandia-doped tungsten nano-particles for high-current-density cathode applicationsInternational Journal of Refractory Metals and Hard Materials, 2013
- Scandate Dispenser Cathode Fabrication for A High-Aspect-Ratio High-Current-Density Sheet Beam Electron GunIEEE Transactions on Electron Devices, 2012
- Emission Characteristics of Nanosized Scandia-Doped Dispenser Cathodes in Open Electron-Gun StructuresIEEE Transactions on Electron Devices, 2011
- Preparation and characterization of scandia-doped tungsten powders prepared by a spray-drying methodResearch on Chemical Intermediates, 2011
- Ab initioinvestigation of barium-scandium-oxygen coatings on tungsten for electron emitting cathodesPhysical Review B, 2010
- Generation of High-Current-Density Sheet Electron BeamsIEEE Electron Device Letters, 2009
- A study of scandia and rhenium doped tungsten matrix dispenser cathodeSolid State Sciences, 2007
- A model system for scandate cathodesApplied Surface Science, 1997