Reservoir Stimulation in Soft Sedimentary Formations: Progress, Challenges and Geothermal Implications
Authors:
- Xiyi LuoXLXiyi Luo
- Pingli LiuPLPingli Liu
- Juan DuJDJuan Du
- Liangbo ZhaoLZLiangbo Zhao
- Jinming LiuJLJinming Liu
- Wenhao TianWTWenhao Tian
- Jinlong LiJLJinlong Li
Preprint
- 30 June 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Soft sedimentary formations, including unconsolidated sandstones, low-strength carbonates, mixed sedimentary rocks and weakly cemented sedimentary geothermal reservoirs, are increasingly important targets for oil and gas production and mid- to deep geothermal development. Their stimulation is limited by poor natural connectivity and the weak stability of grains, pore–fracture boundaries and acid-etched channels. Flow channels created by hydraulic fracturing, acidizing or acid fracturing are prone to proppant embedment, fracture closure, wall weakening, fines migration and pore-throat plugging, causing conductivity loss during production, injection and reinjection.This review examines soft-formation stimulation from the perspective of the trade-off between channel creation and structural stability. The geological–mechanical characteristics and failure mechanisms of unconsolidated sandstones, low-strength carbonates and mixed sedimentary rocks are summarized. Permeability-enhancing stimulation, formation-stabilizing treatment and integrated permeability–stability stimulation are compared in terms of mechanisms, controlling factors and applicability limits. Representative oil and gas and geothermal cases are used to assess whether short-term production or injection improvement can be converted into long-term channel preservation.Existing studies show that stimulation of soft formations cannot be evaluated only by permeability gain, initial productivity or water yield. Permeability-enhancing treatments can improve connectivity but may accelerate wall damage, particle migration and conductivity decline. Stabilization treatments enhance local resistance to mechanical and flow-induced disturbance, but remain constrained by treatment depth, reaction-product distribution, pore-throat damage and thermal stability. Integrated permeability–stability stimulation is promising, but the coupling among channel formation, stabilization timing, reaction location and conductivity retention remains a key barrier to long-term stimulation design.Keywords
This publication has 91 references indexed in Scilit:
- Mechanical properties and behavior of cemented sand in offshore engineering: experimental and simulation insightsJournal of Ocean Engineering and Marine Energy, 2024
- Experimental Investigation of Wormhole Propagation During Alternative Acidizing in Carbonate ReservoirsArabian Journal for Science and Engineering, 2024
- An experimental study of epoxy-based nanocomposite for chemical consolidation in a sandstone reservoir with high clay contentJournal of Petroleum Exploration and Production Technology, 2024
- Sand screen selection by sand retention test: a review of factors affecting sand control designJournal of Petroleum Exploration and Production Technology, 2024
- Evaluation of the effectiveness of mixing hydrochloric acid and organic acid as stimulation fluids in a tight gas carbonate reservoirThe Canadian Journal of Chemical Engineering, 2024
- Microbial‑induced carbonate precipitation (MICP) technology: a review on the fundamentals and engineering applicationsEnvironmental Earth Sciences, 2023
- Pore Structure Characteristics and Evaluation of Carbonate Reservoir: A Case Study of the Lower Carboniferous in the Marsel Exploration Area, Chu-Sarysu BasinNatural Resources Research, 2023
- Study on the critical stress threshold of weakly cemented sandstone damage based on the renormalization group methodInternational Journal of Coal Science & Technology, 2020
- A review of experimental studies on sand screen selection for unconsolidated sandstone reservoirsJournal of Petroleum Exploration and Production Technology, 2020
- Producing Supramolecular Functional Materials Based on Fiber Network ReconstructionAdvanced Functional Materials, 2009