Resolvent-guided optimisation of downstream-edge chamfering for flow-induced noise reduction in a confined orifice
- 21 September 2026
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 1043, A35
Abstract
This study develops a resolvent-guided optimisation framework for reducing flow-induced noise in a confined finite-thickness orifice through downstream-edge chamfering under a pressure-drop constraint. The target response is the downstream transmitted in-duct pressure below the first higher-order duct-mode cut-on. A steady base flow is combined with eddy-viscosity-enhanced resolvent analysis to construct a wall-pressure-related source proxy, and the selected design is assessed using large-eddy simulation. The baseline circular orifice supports strong amplification and intense wall-pressure loading over the downstream inner-orifice wall and immediate postorifice region, where in-hole recirculation, separated shear-layer development, and downstream recovery are strongly coupled. The optimisation identifies an optimal downstream chamfer with a length equal to 55 % of the orifice thickness and a chamfer angle of 50°. Rather than eliminating separation, this geometry redistributes amplification-supporting structures, Reynolds-stress concentrations and wall-pressure fluctuations away from the sharp downstream corner, weakening the compact dipole-source region. The wall-pressure spectra are reduced over almost the entire frequency range below the first higher-order duct-mode cut-on frequency, with strong attenuation of the dominant narrow-band peaks. The duct-based surface-pressure contribution remains dominant in the low Mach-number confined flow but is suppressed more strongly than the volume Reynolds-stress contribution. The residual volume source support is redistributed farther downstream with the displaced shear layer. The selected chamfer further retains a clear source-reduction benefit over a moderate Reynolds number range near the design condition. These results demonstrate an efficient route for pressure-loss-constrained noise reduction in confined internal flows.Keywords
Funding Information
- National Natural Science Foundation of China (12372274)
- China Scholarship Council (202506230376)
- National Research Foundation of Korea (RS-2026-25607329)
This publication has 52 references indexed in Scilit:
- A predictive model for dissolution of stably trapped bubbles in corner cavitiesInternational Journal of Heat and Mass Transfer, 2021
- The acoustics of short circular holes opening to confined and unconfined spacesJournal of Sound and Vibration, 2017
- Concurrent identification of aero-acoustic scattering and noise sources at a flow duct singularity in low Mach number flowJournal of Sound and Vibration, 2016
- An analysis on the pressure loss through perforated plates at moderate Reynolds numbers in turbulent flow regimeFlow Measurement and Instrumentation, 2015
- Large eddy simulations of acoustic-flow interaction at an orifice plateJournal of Sound and Vibration, 2015
- Effects of flow field on the wall mass transfer rate behind a circular orifice in a round pipeInternational Journal of Heat and Mass Transfer, 2014
- Particle image velocimetry measurements of flow field behind a circular square-edged orifice in a round pipeExperiments in Fluids, 2013
- On the pressure losses through perforated platesFlow Measurement and Instrumentation, 2012
- The whistling potentiality of an orifice in a confined flow using an energetic criterionJournal of Sound and Vibration, 2009
- Investigation of damping and radiation using full plane wave decomposition in ductsJournal of Sound and Vibration, 2006