An experimental analysis of the hydrodynamic contribution of textured thrust bearings during steady-state operation: A comparison with the untextured parallel surface configuration
Authors:
- 5 June 2014
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
- Vol. 229 (4) , 362-375
Abstract
Textured surfaces are the subject of a great deal of research work in tribology, which mainly involves numerical studies of lubricated contacts. A variety of shapes and arrangements of textures can be found, these being as numerous as the different authors. Depending on the configuration, it has been shown that the presence of the texture can provide better lubrication efficiency through both a reduction of friction and an increase in load-carrying capacity. However, improving bearing performance implies a specific geometrical configuration for given operating conditions. The improvement in lubricated contact performance by texturing the active surface has been demonstrated using experimental studies concerning, for example, pin-on-disk, mechanical seal, camshaft, journal bearing, thrust bearing, and piston ring set-ups. The objective of the present experimental analysis is to provide, using local measurements, a better understanding of the influence of surface texturing on the steady-state behavior of thrust bearings. To achieve this goal, the experimental device is equipped with 80 sensors such as thermocouples and pressure transducers which allowed a proper assessment of the phenomenology at the film/pad interface. The tests are conducted on five hydrodynamic thrust bearings, among which four are textured. Results show that, for the studied configurations, the textured thrust bearings can help to reduce friction up to 30% at low loads while for heavy loads, their performance is equivalent or even lower than that of an untextured planar bearing.Keywords
This publication has 10 references indexed in Scilit:
- An Experimental Hydrodynamic Thrust Bearing Device and Its Application to the Study of a Tapered-Land Thrust BearingJournal of Tribology, 2014
- Geometry Optimization of Textured 3-D Micro-Thrust Bearings2011
- Optimizing surface texture for hydrodynamic lubricated contacts using a mass-conserving numerical approachProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2010
- Analytical investigation of a partially textured parallel sliderProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2008
- Theoretical and experimental analysis of a partially textured thrust bearing with square dimplesProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2007
- ‘Inlet suction’, a load support mechanism in non-convergent, pocketed, hydrodynamic bearingsProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2006
- Hydrodynamic Performance of a Thrust Bearing with Micropatterned PadsTribology Transactions, 2005
- Experimental Investigation of Laser Surface Textured Parallel Thrust BearingsTribology Letters, 2004
- Paper VI(ii) On the flow perturbations and friction reduction introduced by surface dimples1987
- Film lubrication of plane-faced thrust pads : P. B. Neal, University of SheffieldWear, 1963