A Passive Wireless Switching Array Based on MEMS Switches
Authors:
- 11 September 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 28 (6) , 1013-1018
Abstract
This article proposes a passive wireless switching array based on MEMS switches. By inductive coupling, AC signals are used as both power and control signals at the same time. The switching system includes four switching branches, each of which is composed of a receiving inductor, an AC-DC converting circuit, a MEMS switch, and a load. The detailed design of the circuit part and the MEMS switch are provided, respectively. The MEMS switches are driven by electrostatic combs and are fabricated based on the SOI process. The measured average actuation voltage of the fabricated MEMS switches is 20.4 V. The error between the measured average value and the design value is within 5%. The AC control signals are set to 7.8 MHz, 6 MHz, 4 MHz and 1.8 MHz corresponding respectively to the resonant frequencies of the four switching branches, and their peak to peak voltages are all set to 8V. Experiments verify that each AC control signal can only turn on its corresponding switching branch. Because of its passive wireless control strategy, it has potential applications in multi-channel wake-up systems. [2019-0152]Keywords
Funding Information
- National Key Research and Development Program of China (2018YFB2002500)
This publication has 26 references indexed in Scilit:
- Wireless drive of a MEMS ciliary motion actuator via coupled magnetic resonances using micro inductors2015
- Continuous wireless pressure monitoring and mapping with ultra-small passive sensors for health monitoring and critical careNature Communications, 2014
- An LC-Type Passive Wireless Humidity Sensor System With Portable Telemetry UnitJournal of Microelectromechanical Systems, 2014
- Passive Wireless Sensor Applications for NASA’s Extreme Aeronautical EnvironmentsIEEE Sensors Journal, 2014
- A Harsh Environment-Oriented Wireless Passive Temperature Sensor Realized by LTCC TechnologySensors, 2014
- A wireless chemical sensor featuring iron oxide nanoparticle-embedded hydrogelsSensors and Actuators B: Chemical, 2014
- A piezoelectric flow sensor for use as a wake-up switch for a wireless sensor network nodeMechatronics, 2013
- Monocrystalline-Silicon Microwave MEMS Devices2010
- Capacitive RF MEMS Switches Fabricated in Standard 0.35-$\mu{\hbox{m}}$ CMOS TechnologyIEEE Transactions on Microwave Theory and Techniques, 2010
- Low-actuation voltage RF MEMS shunt switch with cold switching lifetime of seven billion cyclesJournal of Microelectromechanical Systems, 2003