Spectral Design and Experimental Validation of Noncollocated Vibration Suppression by a Delayed Resonator and Time-Delay Controller
- 10 August 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 32 (1) , 73-85
Abstract
A generally applicable spectral design to realize noncollocated vibration suppression performed primarily by a delayed resonator (DR) is presented. The vibration suppression is achieved by direct assignment of imaginary axis zeros of the receptance, i.e., the transfer function between the periodic disturbance force and the target’s displacement. To increase the stability margin and to widen the range of frequencies which can be suppressed, the noncollocated vibration absorption by a DR is supplemented by a stabilizing controller tuned by spectral optimization. A unifying aspect of the resonator and the controller is that both use time-delayed output feedback where both the gains and delays are used as controller parameters. Another important aspect of the proposed method is that it can be applied to a system of general structure, where possibly paths exist between the entry point of the disturbance force and the noncollocated absorber that bypass the suppression target, thereby precluding the existence of a resonating substructure. The proposed method has been experimentally validated on a multi-degree of freedom (DOF) experimental setup actuated by voice coils.Keywords
Funding Information
- Czech Science Foundation (21-00871S)
- Research Foundation-Flanders (G092721N)
- KU Leuven Research Council (CELSA/20/13, C14/22/092)
- Agency of the Czech Technical University in Prague (SGS23/157/OHK2/3T/12)
This publication has 42 references indexed in Scilit:
- A modal filter approach to non-collocated vibration control of structuresJournal of Sound and Vibration, 2013
- Broad band controller design for remote vibration using a geometric approachJournal of Sound and Vibration, 2010
- Active vibration control of a flexible beam using a non-collocated acceleration sensor and piezoelectric patch actuatorJournal of Sound and Vibration, 2009
- A geometric approach to the design of remotely located vibration control systemsJournal of Sound and Vibration, 2008
- An Active Dynamic Vibration Absorber for a Hand-Held Vibro-Elastography ProbeJournal of Vibration and Acoustics, 2006
- Inverse eigenvalue problems in vibration absorption: Passive modification and active controlMechanical Systems and Signal Processing, 2006
- Enforcing nodes at required locations in a harmonically excited structure using simple oscillatorsJournal of Sound and Vibration, 2005
- Imposing nodes at arbitrary locations for general elastic structures during harmonic excitationsJournal of Sound and Vibration, 2004
- AN INVERSE METHOD FOR THE ASSIGNMENT OF VIBRATION NODESMechanical Systems and Signal Processing, 2001
- A Novel Active Vibration Absorption Technique: Delayed ResonatorJournal of Sound and Vibration, 1994