Combustion structure of free and wall-impinging diesel jets by simultaneous laser-induced fluorescence of formaldehyde, poly-aromatic hydrocarbons, and hydroxides
Author:
- 13 June 2008
- journal article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 9 (3) , 249-265
Abstract
The structure of combusting diesel jets in low-temperature conditions is studied using laser-induced fluorescence (LIF). A single-hole common rail diesel injector is used, which allows high injection pressures up to 120 MPa. Visualizations are performed in a high-pressure, high-temperature cell that is designed to reproduce the typical thermodynamic conditions in the combustion chamber of a diesel engine. Planar LIF of the hydroxide (OH) radicals (OH LIF) with excitation near 280 nm and LIF with excitation at 355 nm (355 LIF) are applied simultaneously. In addition, simultaneous 355 LIF imaging and spatially resolved single-shot spectral analysis are performed in order to identify spatially the contribution of formaldehyde and poly-aromatic hydrocarbon (PAH) fluorescence in the 355 LIF images. Also, the analysis of the pressure signal in the chamber and subsequent calculation of heat release rates are used to locate temporally each image within the different combustion stages. The combustion structure of a low-temperature freely propagating jet during those stages is then analysed in detail, using the information given by the simultaneous LIF techniques on the different reaction zones; this is then summarized by a conceptual model. Finally, the simultaneous LIF techniques are applied to a configuration where a jet impinges on a perpendicular wall. The results are used to analyse the effect of wall interaction on the combustion structure.Keywords
This publication has 51 references indexed in Scilit:
- Investigation of the Early Soot Formation Process in a Transient Spray Flame Via Spectral Measurements of Laser-Induced EmissionsInternational Journal of Engine Research, 2006
- Two-dimensional imaging of ignition and soot formation processes in a diesel flameInternational Journal of Engine Research, 2005
- Soot in diesel fuel jets: effects of ambient temperature, ambient density, and injection pressureCombustion and Flame, 2004
- Investigation of the temperature oscillations in the cylinder walls of a diesel engine with special reference to the limited cooled caseInternational Journal of Energy Research, 2004
- Experimental and theoretical study of the short term response temperature transients in the cylinder walls of a diesel engine at various operating conditionsApplied Thermal Engineering, 2004
- Modelling the transient heat transfer in the ceramic combustion chamber walls of a low heat rejection diesel engineInternational Journal of Vehicle Design, 1999
- Heat Transfer With Insulated Combustion Chamber Walls and Its Influence on the Performance of Diesel EnginesJournal of Engineering for Gas Turbines and Power, 1988
- Internal-combustion engine heat transferProgress in Energy and Combustion Science, 1987
- Transient Heat-Flux Measurements in the Combustion Chamber of a Spark-Ignition EngineJournal of Heat Transfer, 1982
- Second Paper: Instantaneous Heat Transfer Rates to the Cylinder Head Surface of a Small Compression-Ignition EngineProceedings of the Institution of Mechanical Engineers, 1970