Weight-Transducerless Rollback Mitigation Adopting Enhanced MPC With Extended State Observer for Direct-Drive Elevators
Authors:
- 1 September 2015
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 31 (6) , 4440-4451
Abstract
The permanent magnet traction machine has become the tendency of modern gearless elevators, because of small volume, high efficiency, and good dynamics. However, the direct-drive elevator car will slide during the electromagnetic brake releasing at elevator startup, if the speed controller cannot generate a suitable electromagnetic torque to trace the change of the uncertain disturbance on traction sheave. To attenuate the car sliding of the gearless elevator installed with an ordinary resolution encoder, a weight-transducerless rollback mitigation strategy adopting an enhanced model predictive control with extended state observer (ESO) for speed loop is proposed. The ESO is used to overcome the mismatch of predictive model caused by the braking torque and the unknown car load. Both the stability and the parameter selection of the observer are analyzed. Additionally, a nonlinear tracking differentiator is used to process the raw speed signal generated by the conventional speed differential sampling instead of the low-pass filter, which can overcome the vibration of the elevator car when the brake releases. Finally, experimental results verify that the proposed control strategy can achieve shorter sliding distance and smaller sliding speed for the direct-drive elevator installed with an ordinary-resolution encoder.Keywords
Funding Information
- Research Fund for the National Science Foundation of China (51207030, 51522701)
- Power Electronics Science and Education Development Program of Delta Environmental and Educational Foundation (DREK2015002)
This publication has 27 references indexed in Scilit:
- Torque-Ripple Minimization and Fast Dynamic Scheme for Torque Predictive Control of Permanent-Magnet Synchronous MotorsIEEE Transactions on Power Electronics, 2014
- Performance of Multistep Finite Control Set Model Predictive Control for Power ElectronicsIEEE Transactions on Power Electronics, 2014
- Predictive Control Method With Future Zero-Sequence Voltage to Reduce Switching Losses in Three-Phase Voltage Source InvertersIEEE Transactions on Power Electronics, 2014
- Weight-Transducerless Starting Torque Compensation of Gearless Permanent-Magnet Traction Machine for Direct-Drive ElevatorsIEEE Transactions on Industrial Electronics, 2013
- Design, Analysis, and Optimization of Ironless Stator Permanent Magnet MachinesIEEE Transactions on Power Electronics, 2013
- Estimation of Load Disturbance Torque for DC Motor Drive Systems Under Robustness and Sensitivity ConsiderationIEEE Transactions on Industrial Electronics, 2013
- Model Predictive Direct Speed Control with Finite Control Set of PMSM Drive SystemsIEEE Transactions on Power Electronics, 2013
- Robust Low-Cost Control Scheme of Direct-Drive Gearless Traction Machine for Elevators Without a Weight TransducerIEEE Transactions on Industry Applications, 2012
- Modelling and design of a direct-drive lift control with rope elasticity and estimation of starting torque2007
- Disturbance and nonlinear luenberger observers for estimating mechanical variables in permanent magnet synchronous motors under mechanical parameters uncertaintiesIEEE Transactions on Industrial Electronics, 2003