A 4 × 4 Fully Integrated RF Transceiver in 6 GHz Frequency Band With Single-Channel Bandwidth of 400 MHz and PHY Data-Rate of 8.8 Gbps
- 18 March 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 72 (5) , 723-727
Abstract
This brief presents a fully integrated CMOS 4×4 MIMO RF transceiver (TRX) with single-channel bandwidth (BW) of 400 MHz in the 6 GHz band (5.925–7.125 GHz). In the receiver (RX) frontend, an improved noise-canceling low noise amplifier (LNA) and a cross-coupled transconductance (GM) with IIP2 enhancement is implemented. In the transmitter (TX) frontend, a power amplifier driver (PAD) is integrated with cascade AM-PM distortion compensation to eliminate the AM-PM distortion. A hierarchical LO distribution network is employed in the 1-to-4 LO distribution chain to enhance the consistency among the LO branches. The single-chip TRX is reconfigurable for TDD/FDD operation, with the RX exhibiting a noise figure of 3.5–4.1 dB, a gain control range of 45 dB with 1 dB step and ±0.2 dB gain flatness. The TX output spectrum exhibits >32 dBc signal to noise ratio (SNR). The RX and TX error vector magnitudes (EVMs) are –30.2 dB and –30.5 dB, respectively, with 160 MHz BW 256QAM. A TX-to-RX PHY data-rate of 8.8 Gbps based on 4×4 MIMO is achieved, with other major parameters comparable to the prior arts without resorting to digital calibration circuits.Keywords
This publication has 21 references indexed in Scilit:
- 6.1 A Low-Power and Low-Cost 14nm FinFET RFIC Supporting Legacy Cellular and 5G FR12021
- Current Status and Directions of IEEE 802.11be, the Future Wi-Fi 7IEEE Access, 2020
- 10.3 A 12nm CMOS RF Transceiver Supporting 4G/5G UL MIMO2020
- 10.4 A 4×4 Dual-Band Dual-Concurrent WiFi 802.11ax Transceiver with Integrated LNA, PA and T/R Switch Achieving +20dBm 1024-QAM MCS11 Pout and −43dB EVM Floor in 55nm CMOS2020
- 21.6 A Sub-6GHz 5G New Radio RF Transceiver Supporting EN-DC with 3.15Gb/s DL and 1.27Gb/s UL in 14nm FinFET CMOS2019
- An 802.11ax 4 $\times$ 4 High-Efficiency WLAN AP Transceiver SoC Supporting 1024-QAM With Frequency-Dependent IQ Calibration and Integrated Interference AnalyzerIEEE Journal of Solid-State Circuits, 2018
- An 802.11a/b/g/n/ac WLAN Transceiver for $2 \times 2$ MIMO and Simultaneous Dual-Band Operation With +29 dBm $\text{P}_{\mathrm {sat}}$ Integrated Power AmplifiersIEEE Journal of Solid-State Circuits, 2017
- 13.8 A 24dBm 2-to-4.3GHz wideband digital Power Amplifier with built-in AM-PM distortion self-compensation2017
- 7.1 An 802.11ac dual-band reconfigurable transceiver supporting up to four VHT80 spatial streams with 116fsrms-jitter frequency synthesizer and integrated LNA/PA delivering 256QAM 19dBm per stream achieving 1.733Gb/s PHY rate2017
- 20.5 A 40nm dual-band 3-stream 802.11a/b/g/n/ac MIMO WLAN SoC with 1.1Gb/s over-the-air throughput2014