Effect of sintering treatment on the microstructure of NiFe2O4 synthesized by the sonochemical method and the conventional method
Open Access
- 1 June 2020
- journal article
- conference paper
- Published by AIP Publishing in AIP Advances
- Vol. 10 (6) , 065103
Abstract
Nickel ferrite ultrafine nanoparticles were synthesized by the sonochemical method. The sample was sintered at temperatures ranging from 1273 K to 1673 K for 3 h. XRD peaks of as-synthesized NiFe2O4, their Transmission Electron Microscopy (TEM), high resolution TEM, and selective area (electron) diffraction pattern demonstrate that the particles are in the completely crystalline state. The initial particle size of as-synthesized NiFe2O4 was found to be approximately 2O4 samples were also synthesized by a conventional double sintering technique. The purpose was to compare the effect of sintering treatment on the microstructure quality of the NiFe2O4 prepared by these two techniques. Homogeneous coaxial grains did not form until 1573 K for conventionally prepared samples, while for the sonochemical method, homogeneous grains started to form even as low as 1373 K. Furthermore, other measurements were done only for the sintered samples prepared by the sonochemical method to evaluate the magnetic properties. An abrupt change in B–H loops was found with Ts for a maximum applied field of 1500 A/m. M–H loops with the maximum applied field of 1.6 × 103 KA/m and Mössbauer spectroscopy demonstrate that the samples are all at the ferrimagnetic stage. Curie temperatures Tc, determined from the temperature dependence of the initial permeability μ′, for the same samples almost remained unchanged, which confirms that the cation distribution is almost unchanged with the variation of Ts. A slight variation of cation distribution manifested in the variation of Tc with Ts conforms with the site occupancy of Fe3+ analyzed by Mössbauer spectroscopy.Keywords
Funding Information
- Government of Bangladesh
- International Science Program, Upsala University
This publication has 32 references indexed in Scilit:
- Magnetic properties of Sn-substituted Ni–Zn ferrites synthesized from nano-sized powders of NiO, ZnO, Fe 2 O 3 , and SnO 2Chinese Physics B, 2017
- Facile synthesis and properties of ZnFe2O4 and ZnFe2O4/polypyrrole core-shell nanoparticlesSolid State Sciences, 2009
- Dependence of magnetic properties on crystallite size of CoFe2O4nanoparticles synthesised by auto-combustion methodJournal of Experimental Nanoscience, 2009
- Synthesis and characterization of Fe and Fe3O4 nanoparticles by thermal decomposition of triiron dodecacarbonylColloids and Surfaces A: Physicochemical and Engineering Aspects, 2009
- Hydrothermal synthesis of monodisperse Fe3O4 nanoparticles based on modulation of tartaric acidColloids and Surfaces A: Physicochemical and Engineering Aspects, 2009
- Structural, magnetic and electrical properties of cobalt ferrites prepared by the sol–gel routeJournal of Alloys and Compounds, 2008
- Sub 5 nm Fe3O4 nanocrystals via coprecipitation methodColloids and Surfaces A: Physicochemical and Engineering Aspects, 2008
- The role of soft colloidal templates in controlling the size and shape of inorganic nanocrystalsNature Materials, 2003
- Grain size effect on the Néel temperature and magnetic properties of nanocrystalline NiFe2O4 spinelJournal of Magnetism and Magnetic Materials, 2002
- Sonochemical Preparation of Nanosized Amorphous NiFe2O4 ParticlesThe Journal of Physical Chemistry B, 1997