SLSamia Islam Liba

Samia Islam Liba

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Samia Islam Liba has a total of 18 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Calamitic ligand design for quantum dot assembly

    by Samia I. Liba, Alauna C. Wheeler, Jocelyn Ochoa, Nicholas Javier C. Licauco, Isabella C. Reyes, Benjamin J. Stokes, Timothy J. Atherton, Linda S. Hirst

    We report the design and use of calamitic ligands for quantum dot surface modification and nanoparticle assembly. Ligands incorporating a rigid aromatic rod-like core have previously been shown to facilitate the formation of porous nanoparticle-based structures, such as solid-walled capsules and multi-compartment quantum dot foams and networks via liquid crystal phase transition templating—a process in which the host phase is quenched through the isotropic-nematic phase transition. The effect of the calamitic ligand structure on particle dispersion, transport, and subsequent assembly, however, requires further investigation, particularly in the case of anisotropic liquid crystal solvents. In this report, we vary the structure of six new calamitic ligands and characterize quantum dot size and packing into superstructures when modified with each ligand. Dynamic light scattering is used to measure the effective nanoparticle size for each ligand in dilute toluene solution. Transmission electron microscopy reveals nanoparticle distribution in dense drop-cast films for each ligand, and small-angle x-ray scattering is used to measure interparticle separations in the assembled porous structures. Together, these methods provide a full picture of particle packing for each ligand. Notably, our findings demonstrate that while longer, more rigid aromatic cores promote a closer packing structure in drop-cast films (a slow quasi-equilibrium process)—such effects are not evident using a rapid quenching method. This study highlights the fact that when nanoparticles are formed into macroscopic assemblies, both ligand design and the particular method of assembly can contribute significantly to the final packing structure.


  • Enhanced photocatalytic activity in RhB dye degradation by Mn and B co-doped mixed phase TiO2 photocatalyst under visible light irradiation

    by Rabeya Sultana, Samia Islam Liba, Md. Abdur Rahman, Nymul Yeachin, Ishtiaque M. Syed, Mahabub Alam Bhuiyan


  • Open Access

    To study the surface modified cobalt zinc ferrite nanoparticles for application to magnetic hyperthermia

    by Suman Halder, S. I. Liba, A. Nahar, S. S. Sikder, S. Manjura Hoque

    In the present work, we have studied the influence of the annealing temperature and concentration of Co0.5Zn0.5Fe2O4 nanoparticles as a heat generation material for hyperthermia therapy. Cobalt zinc ferrite (Co0.5Zn0.5Fe2O4) nanoparticles were synthesized by the chemical co-perception method and annealed at 200 °C, 400 °C, and 600 °C for 3 h. The structural characterization was carried out using an x-ray diffractometer, and all samples exhibit a single-phase spinel structure. The M-H loop of the as-dried and annealed samples revealed a narrow “S” shaped hysteresis cycle, which exhibits the superparamagnetic behavior of all samples. The Mössbauer spectrum of all samples at room temperature showed a doublet, which is the signature of the superparamagnetic nature, and it is in good agreement with the acquired M-H curves. Surface modifications of the as-dried and annealed nanoparticles were achieved by coating the nanoparticles with chitosan, and solutions of different concentrations (1 mg/ml, 2 mg/ml, 4 mg/ml, and 6 mg/ml) were prepared. Employing dynamic light scattering measurement, the hydrodynamic diameter of the chitosan-coated nanoparticles at 37 °C was found to be between 173 nm and 231 nm, and the polydispersity index was less than 0.30 for all concentrations. The induction heating measurements indicated that the heating efficiency of chitosan-coated nanoparticles increased according to the order of annealing temperature (600 °C > 400 °C > 200 °C> as-dried) and the solution of concentration (6 mg/ml > 4 mg/ml > 2 mg/ml > 1 mg/ml).


  • Open Access

    Effect of sintering treatment on the microstructure of NiFe2O4 synthesized by the sonochemical method and the conventional method

    by S. I. Liba, Mehrin Tariq, H. N. Das, A. Nahar, S. Manjura Hoque

    Nickel ferrite ultrafine nanoparticles were synthesized by the sonochemical method. The sample was sintered at temperatures ranging from 1273 K to 1673 K for 3 h. XRD peaks of as-synthesized NiFe2O4, their Transmission Electron Microscopy (TEM), high resolution TEM, and selective area (electron) diffraction pattern demonstrate that the particles are in the completely crystalline state. The initial particle size of as-synthesized NiFe2O4 was found to be approximately 2O4 samples were also synthesized by a conventional double sintering technique. The purpose was to compare the effect of sintering treatment on the microstructure quality of the NiFe2O4 prepared by these two techniques. Homogeneous coaxial grains did not form until 1573 K for conventionally prepared samples, while for the sonochemical method, homogeneous grains started to form even as low as 1373 K. Furthermore, other measurements were done only for the sintered samples prepared by the sonochemical method to evaluate the magnetic properties. An abrupt change in B–H loops was found with Ts for a maximum applied field of 1500 A/m. M–H loops with the maximum applied field of 1.6 × 103 KA/m and Mössbauer spectroscopy demonstrate that the samples are all at the ferrimagnetic stage. Curie temperatures Tc, determined from the temperature dependence of the initial permeability μ′, for the same samples almost remained unchanged, which confirms that the cation distribution is almost unchanged with the variation of Ts. A slight variation of cation distribution manifested in the variation of Tc with Ts conforms with the site occupancy of Fe3+ analyzed by Mössbauer spectroscopy.