Condition Monitoring of Molybdenum Disulphide Coated Thrust Ball Bearings Using Time-Frequency Signal Analysis
- 1 October 2010
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 132 (4) , 041606
Abstract
A method for detection of wear in thrust ball bearings coated with molybdenum disulphide is presented. It employs an energy feature obtained from time-frequency representation of the vibration signal. Extensive experimental studies are conducted to verify the efficacy of the proposed method for fault diagnosis of coating. These experiments are conducted under both oscillatory and unidirectional motions. The results of vibrations are corroborated with the friction coefficient from the onset of the motion until failure develops. Through monitoring of the energy in time-frequency domain as well as the coefficient of friction, three stages of coating life are identified. They are healthy period, developing damage, and failure. It is shown that the energy feature can detect whenever wear and damage appear and solid lubricant loses its lubrication capabilities.
Keywords
This publication has 32 references indexed in Scilit:
- Exponential evolution law of fretting wear damage in low-friction coatings for aerospace componentsSurface and Coatings Technology, 2008
- Different tribological behavior of MoS2 coatings under fretting and pin-on-disk conditionsSurface and Coatings Technology, 2003
- An investigation of molybdenum disulfide bonded solid lubricant coatings in fretting conditionsSurface and Coatings Technology, 2001
- Wear behavior of Pb–Mo–S solid lubricating coatingsWear, 1999
- Wear behavior of triode-sputtered MoS 2 coatings in dry sliding contact with steel and ceramicsWear, 1996
- Paper V (ii) Role of transfer films in wear of MoS2 coatings1990
- A review of recent advances in solid film lubricationJournal of Vacuum Science & Technology A, 1987
- The effect of humidity on the friction and life of unbonded molybdenum disulphide filmsWear, 1969
- Molybdenum disulphide deposits—their formation and characteristics on steel ballsWear, 1966
- JET AND SPACE AGE LUBRICATIONScientific Lubrication, 1960