Thermomechanical and microstructural simulation of rotary friction welding process of Inconel718 alloy using the finite element method
Open Access
- 1 March 2024
- journal article
- Published by Academic World Research in Journal of Computational Methods In Engineering
- Vol. 42 (2) , 129-147
Abstract
Rotary friction welding is one of the most important techniques for joining different parts in advanced industries. Measuring the history of thermomechanical and microstructural parameters can be challenging and costly. To address these challenges, the finite element method was used to simulate thermomechanical and microstructural aspects of the welding of identical superalloy Inconel718 tubes. Therefore, in this research, thermomechanical and microstructural simulations were developed to calculate essential mechanical and metallurgical parameters such as temperature, strain, strain rate, volume fraction of dynamic recrystallization, and grain size distribution. Some of these parameters were then used to be verified with experimental test results. In the microstructural simulation, the Johnson-Avrami model was applied to convert thermomechanical parameters to metallurgical factors by using a FORTRAN subroutine. By employing the dynamic recrystallization kinetics model, the thickness of the recrystallization zone in the wall thickness was calculated to be 480 and 850 micrometers at the center and edge of the tube wall, respectively. These values were reported in the experimental measurements as 500 and 800 micrometers, respectively. Additionally, the grain size change from the center to the edge of the wall thickness, close to the weld interface, were predicted from 2.07 to 2.15 micrometers by simulations, which was comparable with the experimental measurements of 1.9 to 2.2 micrometers. Also, different types of curves were represented to investigate the correlation between thermomechanical and microstructural parameters. Predictable results were concluded from microstructure evolutions with changes by thermomechanical results.Keywords
This publication has 26 references indexed in Scilit:
- Computational modelling of dynamic recrystallisation of Ni-based superalloy during linear friction weldingThe International Journal of Advanced Manufacturing Technology, 2022
- Temperature-mediated tribological characteristics of 40CrNiMoA steel and Inconel 718 alloy during sliding against Si3N4 counterpartsFriction, 2020
- Numerical simulation of plastic deformation in direct-drive friction welding of AISI 4140 and ASTM A106 steel tubesArchives of Civil and Mechanical Engineering, 2020
- Numerical and experimental investigation on friction welding of austenite stainless steel and middle carbon steelJournal of Manufacturing Processes, 2019
- Numerical simulation based upon friction coefficient model on thermo-mechanical coupling in rotary friction welding corresponding with corona-bond evolutionJournal of Manufacturing Processes, 2019
- Modeling of the Dynamic Recrystallization Kinetics of a Continuous Casting Slab Under Heavy ReductionMetallurgical and Materials Transactions A, 2018
- Experimental and numerical studies on friction welding of thixocast A356 aluminum alloyActa Materialia, 2014
- Process parameter analysis of inertia friction welding nickel-based superalloyThe International Journal of Advanced Manufacturing Technology, 2014
- A characterization for the dynamic recrystallization kinetics of as-extruded 7075 aluminum alloy based on true stress–strain curvesComputational Materials Science, 2012
- Thermal-Phase Transformation Modelling and Neural Network Analysis of Friction Welding of Non-Circular Eutectoid Steel ComponentsWelding in the World, 2009