Assessment of solder pad cratering strength using cold pin pull test method with pre-fabricated pin arrays
- 1 May 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 05695503,p. 1788-1793
Abstract
Hot pin pull test is frequently used for the pad crater evaluation. Although it carries several merits, it still has certain drawbacks such as time consuming and causing potential thermal impact on the PCB during the pin attachment process. In this paper, an innovative cold pin pull test method with pre-fabricated pin arrays is introduced. A set of fixture is designed and manufactured in advance. An array of pins can be attached to the test board at one time. With this fixture, instead of attaching the pin one by one, the test panel with pin arrays can be prepared after only two times of reflow without severe thermal impact. Compared with the conventional cold ball pull tests, this newly developed method cannot only equally exhibit the pad crater characteristics of the PCB, but also reduces the scattering in testing results. These conclusions are well proven by the experimental data generated in the present study.Keywords
This publication has 4 references indexed in Scilit:
- Comparative study of PWB pad cratering subject to reflow soldering and thermal impact2010
- Assessment of PCB pad cratering resistance by joint level testing2008
- Development Status of High Speed Ball Pull for Pb-Free BGA Characterization2007 32nd IEEE/CPMT International Electronic Manufacturing Technology Symposium, 2007
- Effects of Testing Conditions and Multiple Reflows on Cold Bump Pull Test of Pb-free Solder Balls2006