Effect of intensified cavitation using poly(vinyl alcohol) microbubbles on spray atomization characteristics in microscale
Open Access
- 1 February 2020
- journal article
- conference paper
- Published by AIP Publishing in AIP Advances
- Vol. 10 (2) , 025318
Abstract
In this study, cavitating flows inside a transparent cylindrical nozzle with an inner diameter of 0.9 mm were visualized, and the effect of cavitation on atomization characteristics of emerging sprays was investigated. Different patterns of cavitating flows inside the nozzle were visualized using a high-speed camera. In-house codes were developed to process the captured images to study the droplet size distribution and droplet velocity in different flow regimes. The results show that cavitating flows at the microscale have significant effects on atomization characteristics of the spray. Two working fluids, namely, water and poly(vinyl alcohol) microbubble (PVA MB) suspension, were employed. Accordingly, the injection pressures were detected as 690 kPa, 1035 kPa, and 1725 kPa for cavitation inception, supercavitation, and hydraulic flip flow regimes in the case of water, respectively. The corresponding pressures for the aforementioned patterns for PVA MB suspension were 590 kPa, 760 kPa, and 1070 kPa, respectively. At the microscale, as a result of a higher volume fraction of cavitation bubbles inside the nozzle, there is no large difference between the cavitation numbers corresponding to cavitating and hydraulic flip flows. Although the percentage of droplets with diameters smaller than 200 μm was roughly the same for both cases of water and PVA MB suspension, the Sauter mean diameter was considerably lower in the case of PVA MBs. Moreover, higher droplet velocities were achieved in the case of PVA MBs at lower injection pressures.Keywords
Funding Information
- Sabanci University (I.A.CF-18-01877)
- TÜBİTAK (118S040, 217M869)
This publication has 37 references indexed in Scilit:
- Effect of fuel temperature on in-nozzle cavitation and spray formation of liquid hydrocarbons and alcohols from a real-size optical injector for direct-injection spark-ignition enginesInternational Journal of Heat and Mass Transfer, 2010
- Influence of cavitation phenomenon on primary break-up and spray behavior at stationary conditionsFuel, 2010
- Cavitation, primary break-up and flash boiling of gasoline, iso-octane and n-pentane with a real-size optical direct-injection nozzleFuel, 2010
- Ligament Formation Induced by Cavitation in a Cylindrical NozzleJournal of Fluid Science and Technology, 2008
- Effects of cavitation in a nozzle on liquid jet atomizationInternational Journal of Heat and Mass Transfer, 2007
- Tethering Functional Ligands onto Shell of Ultrasound Active Polymeric MicrobubblesBiomacromolecules, 2006
- Using spray momentum flux measurements to understand the influence of diesel nozzle geometry on spray characteristicsFuel, 2005
- The influence of cavitation on the internal flow and the spray characteristics in diesel injection nozzlesFuel, 2004
- DRYING MECHANISM OF COATED FILM OF POLYMER SOLUTIONJOURNAL OF CHEMICAL ENGINEERING OF JAPAN, 1974
- Flow Pattern in Diesel Nozzle Spray HolesProceedings of the Institution of Mechanical Engineers, 1959