Mechanical Behaviour of a NTO and RDX‐Based Melt Cast Explosive
- 28 May 2020
- journal article
- research article
- Published by Wiley in Propellants, Explosives, Pyrotechnics
- Vol. 45 (8) , 1281-1292
Abstract
Constitutive equationsThe XF explosive family from NEXTER Munitions relies on a melt cast formulation with a TNT matrix. Melt cast formulations provide a high‐volume ratio of energetic filler material to matrix. This might affect the mechanical response of the material and its damage process. Therefore, a laboratory study has been launched to improve the knowledge of the mechanical behavior of this family of energetic materials. To mimic the conditions observed by the material inside ammunition, we chose to adapt a passive confinement method to the pyrotechnic conditions of the XF‐11585. This relies on an elastic‐perfectly plastic ring that gives us access to the shear behavior for different loadings in quasi‐static regime. This setup allowed us to investigate the physical phenomena involved under both pressure and shear. Then, based on the results obtained, we built an isotropic elastic damage model. This macroscopic modeling of damage is meant to be simple but complex enough to provide an assessment of the material degradation.Keywords
Funding Information
- NEXTER Munitions Bourges
This publication has 10 references indexed in Scilit:
- Low energy shock response of a melt cast simulant materialEPJ Web of Conferences, 2018
- Laboratory Setback Activator Tests for Gun Launch Explosive Suitability2017
- Dynamic Compressive Properties of Polymer Bonded Explosives under Confining PressurePropellants, Explosives, Pyrotechnics, 2017
- Detonation initiation of heterogeneous melt-cast high explosivesAIP Conference Proceedings, 2017
- Numerical and experimental study of the plasticity of HMX during a reverse edge-on impact testModelling and Simulation in Materials Science and Engineering, 2013
- Review on Melt Cast ExplosivesPropellants, Explosives, Pyrotechnics, 2011
- Dynamic behavior of an aggregate material at simultaneous high pressure and strain rate: SHPB triaxial testsInternational Journal of Impact Engineering, 2011
- An experimental method of measuring the quasi-static and dynamic confined behaviour of PMMAEPJ Web of Conferences, 2010
- Use of a macroscopic model for describing the effects of porosity on shock wave propagationJournal of Applied Physics, 2007
- Application of Continuous Damage Mechanics to Strain and Fracture Behavior of Concrete1985