Sliding wear behaviour of Al-Si alloy–fly ash composites produced by powder metallurgy technique
- 13 March 2017
- journal article
- research article
- Published by Emerald Publishing in Industrial Lubrication and Tribology
- Vol. 69 (2) , 241-247
Abstract
Purpose: Metal matrix composites (MMCs) are commonly used in many aerospace and industrial applications. MMCs possess significantly improved properties including high specific strength, specific modulus, damping capacity and good wear resistance compared to unreinforced alloys. The purpose of this paper is to describe the tribological studies of Al-Si alloy–fly ash composites manufactured using powder metallurgy technique. Design/methodology/approach: Al-Si (12 Wt.%) alloy–fly ash composites were developed using powder metallurgy technique. Al-Si alloy powder was used as matrix material, and the fly ash was used as reinforcement. The particle size of Al-Si alloy powder was in the range of 75-300 μm, and the fly ash was in the range of 1-15 μm. The friction and wear characteristics of the composites were studied using a pin-on-disc set up. The test specimen was mated against cast iron disc, and the tests were conducted with the loads of 10, 20 and 30 N, sliding speeds of 0.5, 1 and 1.5 m/s for a sliding distance of 2,000 m. Findings: The effects of load and sliding speed on tribological properties of the base alloy and Al-Si alloy–fly ash composites pins on sliding with cast iron disc are evaluated. The wear rate of Al-Si alloy–fly ash composites is lower than that of base alloy, and it increases with increasing load and sliding speed. The coefficient of friction of Al-Si alloy–fly ash composites is increased as compared with base alloy. Practical implications: The development of Al-Si alloy–fly ash composites produced by powder metallurgy technique will modernize the automobile and other industries because near net shape at low cost and good mechanical properties are obtained. Originality/value: There are few papers available on the development and tribological studies of Al-Si alloy–fly ash composites produced by powder metallurgy technique.Keywords
This publication has 17 references indexed in Scilit:
- Microstructural characterization and mechanical property of Fly Ash/Al-25Mg compositesJournal of Wuhan University of Technology-Mater. Sci. Ed., 2014
- Effect of particle size on mechanical properties and tribological behaviour of aluminium/fly ash compositesScience and Engineering of Composite Materials, 2012
- Multi-response optimisation of sintering parameters of Al–Si alloy/fly ash composite using Taguchi method and grey relational analysisThe International Journal of Advanced Manufacturing Technology, 2009
- Fabrication and characterisation of Al–7Si–0.35Mg/fly ash metal matrix composites processed by different stir casting routesComposites Science and Technology, 2007
- Effect of reinforcement of flyash on sliding wear, slurry erosive wear and corrosive behavior of aluminium matrix compositeWear, 2007
- Deformation Behavior of Cold Upset Forming of Sintered Al-Fe Composite PreformsJournal of Engineering Materials and Technology, 2005
- Preparation of aluminium-fly ash particulate composite by powder metallurgy techniqueJournal of Materials Science, 1997
- Friction and abrasion resistance of cast aluminum alloy-fly ash compositesMetallurgical and Materials Transactions A, 1997
- Compacting characteristics of aluminium-fly ash powder mixturesJournal of Materials Science, 1996
- Metal-matrix composites: Manufacturing aspects. Part IJournal of Materials Processing Technology, 1993