Thermomechanical analysis in electronic packaging with unified constitutive model for materials and joints
Authors:
- C. BasaranCBC. Basaran
- T. DishonghTDT. Dishongh
- J.L. PrinceJPJ.L. Prince
- 1 February 1998
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging, and Manufacturing Technology: Part B
- Vol. 21 (1) , 87-97
Abstract
A unified constitutive modeling approach based on the disturbed state concept (DSC) provides improved characterization of thermomechanical response of joining (solders), ceramics and printed wire board (PWB) materials in electronic packaging. Various versions in the DSC approach are calibrated and validated with respect to laboratory test data, and are implemented in a nonlinear finite element (FE) procedure. The hierarchical nature of this procedure permits the user to choose a constitutive model, simple (elastic) to sophisticated (elastovisco-plastic with disturbance), depending upon the material and need. The FE is used to analyze thermomechanical behavior of two typical problems: (1) leadless ceramic chip carrier (LCCC) package; (2) solder ball connect (SBC) package. The FE results under cyclic thermal loading are compared with experimental data for the two packages, and with a previous FE analysis for the SBC package. In conjunction with the idea of critical disturbance at which thermal fatigue failure can occur, the analyzes allow identification of cycles to failure, N/sub f/, and evaluation of reliability of the package. In the case of the SBC package, the analysis permits an evaluation of ball spacing on the thermomechanical behavior. The DSC approach can provide an integrated and improved procedure compared to available models for elastic, plastic, creep strains, and microcracking leading to degradation of strength and fatigue failure for a wide range of problems in electronic packaging under thermomechanical loading.Keywords
This publication has 13 references indexed in Scilit:
- Handbook of Electronic Package DesignJournal of Electronic Packaging, 2000
- Thermomechanical Response of Materials and Interfaces in Electronic Packaging: Part I—Unified Constitutive Model and CalibrationJournal of Electronic Packaging, 1997
- Disturbed state constitutive modeling based on stress-strain and nondestructive behaviorInternational Journal of Solids and Structures, 1996
- Isothermal Fatigue of LCC/PWB InterconnectionsJournal of Electronic Packaging, 1992
- Fatigue Properties of Microelectronics Solder JointsJournal of Electronic Packaging, 1991
- Thermal Cycling Induced Plastic Deformation in Solder Joints—Part I: Accumulated Deformation in Surface Mount JointsJournal of Electronic Packaging, 1991
- Solder Joint Reliability1991
- Analytical Modeling in Electronic Packaging Structures: Its Merits, Shortcomings and Interaction With Experimental and Numerical TechniquesJournal of Electronic Packaging, 1989
- Introduction to continuum damage mechanics1986
- On The Yielding of SoilsGéotechnique, 1958