B4C‐Reinforced Al–Zn Foams Having Superior Energy Absorption Efficiency
- 11 September 2022
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 25 (1)
Abstract
The low density of the aluminium foam and high energy absorption make them favourable for automobile, aerospace, and defence industries. However, the melt route for foam fabrication has challenges in achieving homogeneous distribution of pores. Hence, we have adopted the space holder technique using the powder metallurgy methodology to overcome such a challenge. In the current study, we fabricated Al–Zn alloy foams reinforced with varying volume fractions of B4C particles using NaCl as a space holder implemented by hot pressure‐assisted sintering and dissolution. X‐ray computed tomography revealed a homogeneous distribution of pores. The quasistatic compression studies showed that the samples containing a higher volume fraction of pores exhibited higher energy absorption efficiency in the fabricated foam. The maximum energy absorption efficiency (η) achieved was ≈93% for the pristine Al alloy foam with ≈50% porosity, which is ≈11% higher than the η value of 9 vol% B4C samples with similar porosity. Additionally, B4C particles delay the sudden collapse of cell walls and stabilize the compression behaviour. Adding B4C improves the η and strength at higher relative density. This fabrication methodology would help us develop foams with a homogenous pore distribution and regular geometry, achieving highly desirable mechanical properties.Keywords
This publication has 60 references indexed in Scilit:
- Mechanical Properties of Aluminium Foam by Conventional Casting Combined with NaCl Space HolderApplied Mechanics and Materials, 2013
- Compressive properties and energy absorption behavior of Al–Al2O3 composite foam synthesized by space-holder techniqueMaterials & Design (1980-2015), 2012
- Defect generation during solidification of aluminium foamsScripta Materialia, 2010
- Compressive property and energy absorption characteristic of open-cell SiCp/AlSi9Mg composite foamsJournal of Alloys and Compounds, 2010
- Composite Production by Pressure InfiltrationMaterials Science Forum, 2008
- The effect of structural defects on the compressive behavior of closed-cell Al foamActa Materialia, 2005
- Static and dynamic energy absorption of Al foams produced by the sintering and dissolution processMetallurgical and Materials Transactions B, 2003
- Metal Foams: A Design GuideApplied Mechanics Reviews, 2001
- The effect of cell wall microstructure on the deformation and fracture of aluminium-based foamsActa Materialia, 2001
- Manufacture, characterisation and application of cellular metals and metal foamsProgress in Materials Science, 2001