Experimental investigation of turbulent flow through a square-sectioned duct and 90ᵒ square elbow by using circular turbulator
Open Access
- 29 March 2024
- journal article
- research article
- Published by OU Scientific Route in EUREKA: Physics and Engineering
- No. 2,p. 45-54
Abstract
The ducting system is made up of 90° elbows and a few other fittings and accessories in addition to straight ducts. The friction loss, separation loss, and secondary flow loss are the main causes of the pressure decrease in an elbow, and they all increase with the presence of elbows. Utilizing too much energy to propel the flow is a cost associated with pressure loss. The aim of this research is to investigate turbulent flow via 90° square elbows and a square-sectioned duct through experimental methods by adding a circular turbulator (CT) close to the elbow wall's inner radius. The Reynolds numbers (ReDh) used in this research are 1.6×104, 4.8×104, and 9.5×104, with average flow velocities of 2 m/s, 6 m/s, and 12 m/s. Circular turbulators are added to the inner walls with angular positions (α) of 5°, 10°, 15°, and 20°. The results showed that the turbulence intensity increased toward the inner radius wall of the elbow in ducting with CT. For this study, the flow within the ducting with the CT is generally more turbulent than the flow inside the ducting without the CT. By including CT, it was possible to reduce the overall pressure loss in ducting with an elbow. The pressure reduction at two ReDh values (1.6×104 and 4.8×104) was only lessened by CT positioned at α=10°, 15°, and 20° out of the four CT placements. Conversely, CT positioned at α=5° can only effectively mitigate pressure decrease at ReDh=1.6×104. CT installation cannot lessen the pressure drop that happens in the ducting at a value of ReDh=9.5×104. CT placement at the three α values often helps to lower the pressure drop in the ducting. Using the CT, positioned at α=15°, is the greatest strategy to reduce the overall pressure decreaseKeywords
This publication has 21 references indexed in Scilit:
- Characteristics of turbulent boundary layers generated by different tripping devicesInternational Journal of Heat and Fluid Flow, 2023
- A review of ductless mini split HVAC systemEnergy Reports, 2022
- Radiation noise control of a 90° rectangular elbow in ventilation and air conditioning systemsJournal of Building Engineering, 2021
- Laminar flow and heat transfer in U-bends: The effect of secondary flows in ducts with partial and full curvatureInternational Journal of Thermal Sciences, 2018
- Flow development in curved rectangular ducts with continuously varying curvatureExperimental Thermal and Fluid Science, 2016
- Research on flow in 90° curved duct with round sectionPhysics Procedia, 2012
- Analysis of turbulent flow through a square-sectioned duct with installed 90-degree elbowFlow Measurement and Instrumentation, 2011
- Reduction of fluid forces acting on a single circular cylinder and two circular cylinders by using tripping rodsJournal of Fluids and Structures, 2003
- GROUND EFFECT OF FLOW AROUND AN ELLIPTIC CYLINDER IN A TURBULENT BOUNDARY LAYERJournal of Fluids and Structures, 2000
- Forces on a circular cylinder near a plane wallApplied Ocean Research, 1985