Numerical Simulation of Gas Flow Passing through Slots of Various Shapes in Labyrinth Seals
Open Access
Abstract
Labyrinth seals are widely used in centrifugal compressors, turbines, and many other pneumatic systems due to their simplicity of design, reliability, and low cost. The calculation scheme for the movement of the working medium in a labyrinth seal is constructed by analogy with the movement of the working medium through holes with a sharp edge. Annular and flat slots, holes, and such a factor as the shaft rotation with a calculated sector of 3 degrees were studied. The purpose of the study is to determine the flow coefficient when the working medium flows through slots of various shapes. To achieve this purpose, modeling of the working medium flow in the FlowVision software was performed. The mass flow and flow coefficients are determined for the studied slot shapes. The convergence of the calculation results was determined by comparing the values of the mass flow rate at the inlet and outlet of the slot. Differences in visualizations of the flow for the studied variants of slots were established. The resulting difference should be taken into account in practical calculations of the working medium mass flow through the slot using a conditional flow rate factor which is determined by the slot design.Keywords
Funding Information
- Agentúra na Podporu Výskumu a Vývoja (APVV-15-0602)
- Ministerstvo školstva, vedy, výskumu a športu Slovenskej republiky (VEGA 1/0704/22)
This publication has 15 references indexed in Scilit:
- Swirl brakes optimization for rotordynamic performance improvement of labyrinth seals using computational fluid dynamics methodTribology International, 2021
- Research on leakage performance and dynamic characteristics of a novel labyrinth seal with staggered helical teeth structureAlexandria Engineering Journal, 2021
- Multiphase model of flow and separation phases in a whirlpool: Advanced simulation and phenomena visualization approachJournal of Food Engineering, 2020
- Solving the Coupled Aerodynamic and Thermal Problem for Modeling the Air Distribution Devices with Perforated PlatesEnergies, 2019
- Numerical Investigation on the Leakage and Rotordynamic Characteristics for Three Types of Annular Gas Seals in Wet Gas ConditionsJournal of Engineering for Gas Turbines and Power, 2018
- Experimental investigation of effect of tooth geometrical parameters to flow characteristics in slant labyrinth sealsConcurrency and Computation: Practice and Experience, 2018
- Numerical study on the effect of geometrical parameters on the labyrinth–honeycomb seal performanceProceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 2017
- Leakage Degradation of Straight Labyrinth Seal Due to Wear of Round Tooth Tip and Acute Trapezoidal Rub-GrooveJournal of Engineering for Gas Turbines and Power, 2017
- Numerical comparisons of rotordynamic characteristics for three types of labyrinth gas seals with inlet preswirlProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2016
- Flow Simulation in a Labyrinth SealApplied Mechanics and Materials, 2014