Semi-Continuous Equal-Channel Angular Extrusion and Rolling of AA5083 and AZ31 Alloys
Open Access
Abstract
This paper describes a new modification of equal-channel angular extrusion for the “pass-by-pass” semi-continuous (sc-ECAE) processing of lightweight alloys. Sc-ECAE leads to a multifold increase in productivity and decrease in costs, providing a technical basis for the commercialization of severe plastic deformation (SPD) on a large scale with massive volume production. The evolution of the structure and properties are analyzed for an aluminum alloy (AA) 5083 and a magnesium alloy AZ31 as model materials representing, respectively, the structural refinement under severe plastic deformation (SPD) via strain-induced formation of new grain boundaries and via dynamic recrystallization. For the first alloy, the microstructure after sc-ECAE is formed via ultrafine sub-grains, which are further transformed into sub-micrometer grains during post-ECAE rolling. The preliminary solution treatment of AA5083 is an important stabilizing factor for the achievement of high mechanical properties. For the second alloy, optimized sc-ECAE results in a remarkable structural refinement, and a good balance of properties is obtained with a low number of passes. However, additional rolling in the latter case leads to a degradation of the structure and properties.Keywords
This publication has 17 references indexed in Scilit:
- Review: Modes and Processes of Severe Plastic Deformation (SPD)Materials, 2018
- Tailoring Microstructure and Properties of Fine Grained Magnesium Alloys by Severe Plastic DeformationAdvanced Engineering Materials, 2017
- Improvement of superplasticity in AA5083 by equal channel angular extrusion and rollingMaterials Science and Technology, 2017
- Producing High‐Strength Metals by I‐ECAPAdvanced Engineering Materials, 2015
- Processing magnesium alloys by severe plastic deformationIOP Conference Series: Materials Science and Engineering, 2014
- Effects of solution heat treatment on corrosion resistance of 5083F Al alloyTransactions of Nonferrous Metals Society of China, 2009
- Improving both strength and ductility of a Mg alloy through a large number of ECAP passesMaterials Science and Engineering: A, 2009
- Microstructure evolution of AZ31 Mg alloy during equal channel angular extrusionMaterials Science and Engineering: A, 2006
- A New Configuration for Equal Channel Angular Extrusion DiesJournal of Manufacturing Science and Engineering, 2006
- Structural and mechanical properties in AA 5083 processed by ECAEMaterials Science and Technology, 2000