Adhesion performance of UHMWPE after different surface modification techniques
Authors:
- R. OosteromROR. Oosterom
- T.J. AhmedTAT.J. Ahmed
- J.A. PoulisJPJ.A. Poulis
- H.E.N. BerseeHBH.E.N. Bersee
- 22 August 2005
- journal article
- research article
- Published by IOP Publishing in Medical Engineering & Physics
- Vol. 28 (4) , 323-330
Abstract
A novel design of an ultra-high molecular weight polyethylene (UHMWPE) glenoid component has been proposed, based on adhesion to PMMA bone cement. However, due to the non-polar nature of UHMWPE, surface modification techniques are needed to obtain good adhesion and thus for the design to be viable. The aim of the study is to investigate adhesion of UHMWPE after different surface treatments. Three gas-phase surface modification techniques were investigated, namely UV/Ozone, corona discharge and radio frequency glow discharge plasma, as well as abrasion. The surface treated samples were examined using water contact angle, surface energy and roughness measurements, as well as single lap-joint shear testing using polymethylmethacrylate (PMMA) bone cement and methylmethacrylate (MMA) adhesive. The effect of aging on bonded samples has also been investigated. Corona and glow discharge treatments were found to activate the surface as shown by an increase in surface energy of over 100% in an order of less than a minute, corresponding to an increase in ultimate shear stress from 0.12 to 0.40 MPa. In contrast, UV/Ozone required exposure times in the order of minutes to have an effect that was still incomparable to the other gas-phase treatments examined. Abrasion produced slightly better adhesion properties for single lap-joints bonded with PMMA compared to the corona treatment. The best treatment was found to be a combined treatment of surface roughening for 10 s, and subsequently a 90 s glow discharge treatment, resulting in failure of the UHMWPE sheet material.Keywords
This publication has 17 references indexed in Scilit:
- Preliminary study of interfacial shear strength between PMMA precoated UHMWPE acetabular cup and PMMA bone cementJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2003
- Surface modification of spin-coated high-density polyethylene films by argon and oxygen glow discharge plasma treatmentsApplied Surface Science, 2002
- Reimplantation of a glenoid component after component removal and allograft bone grafting: A report of 3 casesJournal of Shoulder and Elbow Surgery, 2002
- Plasma-surface modification of biomaterialsMaterials Science and Engineering: R: Reports, 2002
- Characterisation and comparison of industrially pre-treated homopolymer polypropylene, HF 135MInternational Journal of Adhesion and Adhesives, 2002
- Adhesion behaviour of polypropylenes after flame treatment determined by XPS(ESCA) spectral analysisJournal of Electron Spectroscopy and Related Phenomena, 2001
- Corona, spark and combined UV and ozone modification of polymer films WeBP23Surface and Coatings Technology, 1998
- Gamma sterilization of UHMWPE articular implants: an analysis of the oxidation problemBiomaterials, 1996
- Functional Improvement and Costs of Hip and Knee Arthroplasty in Destructive Rheumatoid ArthritisScandinavian Journal of Rheumatology, 1991
- The mechanism of corona and ultraviolet light‐induced self‐adhesion of poly(ethylene terephthalate) filmJournal of Applied Polymer Science, 1975