The FEA and experimental stress analysis in circular perforated plates loaded with concentrated force
Open Access
- 7 December 2019
- journal article
- research article
- Published by Gruppo Italiano Frattura in Fracture and Structural Integrity
- Vol. 14 (51) , 164-173
Abstract
The paper presents an analysis of an isotropic circular axisymmetric perforated plate loaded with concentrated force Pi applied in the geometric center of the plate using finite element software ANSYS. The test plate with diameter D = 300 mm has holes in ten circles. The plate has holes with diameter d1 = 3.5 mm on the first inner circle, and holes on the tenth outside circle have a diameter d10 = 20.5 mm. The plate of the above geometry was free supported and loaded with different values of concentrated force. By means of numerical calculations using the finite element method, the coordinates of concentration zones of reduced stress in the perforated plate were determined. These zones were located on the plate bridges between perforation holes. The most hazardous place in the analyzed perforated plate is associated with the tenth zone Z10 with the hole radius d1 = 3.5 mm at the circle radius R1 = 22.5 mm, where the highest stress concentration occurs. In this zone, the reduced stress is σred max = 416.90 MPa (point with the coordinates x, y, z [mm], i.e. P10 [-69.9; 72.5; 0.0]). The results of numerical calculations were verified with experimental results. The differences between the results of numerical calculations of the state of stress and those obtained experimentally did not exceed 36%.Keywords
This publication has 8 references indexed in Scilit:
- Linear static analysis of perforated plates with round and staggered holes under their self-weightsResearch on Engineering Structures and Materials, 2016
- Exact solutions of stresses, strains, and displacements of a perforated rectangular plate by a central circular hole subjected to linearly varying in-plane normal stresses on two opposite edgesInternational Journal of Mechanical Sciences, 2014
- Finite Element Analysis Based Structural Analysis of Stacked Heat ExchangerIOSR Journal of Mechanical and Civil Engineering, 2014
- Strength tests of axially symmetric perforated plates for chemical reactors: Part 2—ExperimentsInternational Journal of Pressure Vessels and Piping, 2008
- Strength tests of axially symmetric perforated plates for chemical reactors: Part 1—The simulation of stress stateInternational Journal of Pressure Vessels and Piping, 2008
- Ultimate strength of perforated steel plates under combined biaxial compression and edge shear loadsThin-Walled Structures, 2008
- Yield criterion for a perforated sheet with a uniform triangular pattern of round holes and a low ligament ratioJournal of Materials Processing Technology, 2000
- Analysis of the deformation of a perforated sheet under uniaxial tensionJournal of Materials Processing Technology, 1996