MKMateusz Konieczny

Mateusz Konieczny

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mateusz Konieczny has a total of 3 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    The FEA and experimental stress analysis in circular perforated plates loaded with concentrated force

    by Mateusz Konieczny, Grzegorz Gasiak, Henryk Achtelik

    The paper presents an analysis of an isotropic circular axisymmetric perforated plate loaded with concentrated force Pi applied in the geometric center of the plate using finite element software ANSYS. The test plate with diameter D = 300 mm has holes in ten circles. The plate has holes with diameter d1 = 3.5 mm on the first inner circle, and holes on the tenth outside circle have a diameter d10 = 20.5 mm. The plate of the above geometry was free supported and loaded with different values of concentrated force. By means of numerical calculations using the finite element method, the coordinates of concentration zones of reduced stress in the perforated plate were determined. These zones were located on the plate bridges between perforation holes. The most hazardous place in the analyzed perforated plate is associated with the tenth zone Z10 with the hole radius d1 = 3.5 mm at the circle radius R1 = 22.5 mm, where the highest stress concentration occurs. In this zone, the reduced stress is σred max = 416.90 MPa (point with the coordinates x, y, z [mm], i.e. P10 [-69.9; 72.5; 0.0]). The results of numerical calculations were verified with experimental results. The differences between the results of numerical calculations of the state of stress and those obtained experimentally did not exceed 36%.


  • State of stress in the plate with slot at biaxial load

    by Mateusz Konieczny, Grzegorz Gasiak

    The numerical calculations of the state of reduced stress in the plate with the slot at the biaxial load made it possible to determine areas of stress concentration around the top of the aperture. It was shown that the highest of reduced stress concentration occurred in the plate with both an elliptical and flat slot, when the slope longer axis forms of the slot an angle of 45° for a biaxial load, i.e. extension Pz = 300 kN and compression Py = −300 kN. The concentration of reduced stress factor k depending on the method of plate load and the angle of inclination of the slot was from 2.53 to for the elliptical slot and from 3.26 to 5.18 for the flat slot. Significant values reduced stress concentration in the top area of the slot are usually the cause of micro cracks, which under the influence of variable loads may initiate the propagation of fatigue cracks and lead to the destruction of the machine element.