Development of a dissolved polystyrene matrix composite reinforced with coconut fibre particles
Authors:
- 28 May 2026
- journal article
- Published by SAGE Publications in Progress in Rubber, Plastics and Recycling Technology
Abstract
A new sustainable and environmentally friendly composite material has been developed from coconut fibre particles and recycled polystyrene dissolved in chloroform. Three particle sizes and four reinforcement ratios were used. The composite was moulded by cold pressing without measuring the pressure but by fixing the thickness. The density (592.53 – 723.03) kg.m -3 shows the lightness of the material. The moisture content (6.63 – 8.35%), water absorption rate (54.06 – 109.42) % and thickness swelling rate (2.86 – 16.09) % are within the acceptable range of ≤16% for use in dry and wet areas, except for formulations with a 55% reinforcement rate. The absorption kinetics of the composites produced show hydrophilicity and correlate with Page’s model. Microscopic examination shows better interfacial cohesion with low visible porosity for composites with the lowest particle content and reinforcement rate. Young’s modulus (129.29 – 530.95) MPa and mechanical stress at break (1.26 – 6.508) MPa are relatively low compared to structural materials. Thermal conductivity (0.22 – 0.347) W.m -1 .k -1 and thermal effusivity (571.9 – 856.7) J.m -2 .K -1 .S -1/2 are within the range of thermally insulating materials. Smaller particles show better cohesion with the matrix. These materials are intended for use in furniture, false ceilings, house partitions, computer stands and telephone booth doors.Keywords
This publication has 49 references indexed in Scilit:
- Coconut fibers: a sustainable alternative to expanded polystyrene: a reviewCellulose, 2025
- Effect of particle sizes on physical, thermal and mechanical behavior of a hybrid composite with polymer matrix with raffia vinifera cork and Bambusa vulgarisPolymer Bulletin, 2023
- Influence of moisture content on the thermophysical properties of tropical wood speciesHeat and Mass Transfer, 2019
- Recent developments in recycling of polystyrene based plasticsCurrent Opinion in Green and Sustainable Chemistry, 2018
- Characterization of new composite material based on date palm leaflets and expanded polystyrene wastesConstruction and Building Materials, 2018
- Polystyrene recycling processes by dissolution in ethyl acetateJournal of Applied Polymer Science, 2018
- Palm leave and plastic waste wood composite for out-door structuresConstruction and Building Materials, 2013
- Influence of hygrothermal ageing on the damage mechanisms of flax-fibre reinforced epoxy compositeComposites Part B: Engineering, 2013
- Properties of binderless particleboard from oil palm trunk with addition of polyhydroxyalkanoatesComposites Part B: Engineering, 2012
- Recycling extruded polystyrene by dissolution with suitable solventsJournal of Material Cycles and Waste Management, 2009