Estimation of the Coefficient of Friction in Dissimilar Metals of Cu to SS Friction Weld Joints for NBI Ion Extractor Grid Fabrication
- 26 November 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 54 (6) , 2450-2455
Abstract
This article investigates friction welding (FW) between electrolytic tough pitch copper (Cu) and 304 stainless steel (SS) in a rod joint configuration with a 16 mm diameter, utilizing the continuous drive FW technique. This welding was conducted by varying friction pressure (FP) and upset pressure (UP), while other parameters remained constant. From the welding parameters, the “coefficient of friction” (COF) was estimated, which is found in the range of 0.18–0.40. The concept of the COF is widely applied in both science and engineering. The variation in COF during the FW process affected the torque, which ranged from 12.13 to 16.2 Nm, and the power, which varied between 2094 and 2902 W. Changes in COF, torque, and power were governed by the applied pressure, which, in turn, influenced the strength of the welded joints. Notably, higher COF values corresponded to significant improvements in the tensile strength of the joint. All samples fractured on the Cu side, away from the interface, with the maximum recorded tensile strength reaching 202 MPa.Keywords
This publication has 13 references indexed in Scilit:
- Analysis of Mechanical and Microstructural Properties in Larger-Sized Electrolytic Tough Pitch Copper to SS304L Pipe Joints Produced by Friction WeldingJournal of Materials Engineering and Performance, 2025
- Microstructure evolution and mechanical properties of continuous drive friction welded dissimilar copper-stainless steel pipe jointsMaterials Science and Engineering: A, 2022
- Friction welding of dissimilar joints copper-stainless steel pipe consist of 0.06 wall thickness to pipe diameter ratioJournal of Manufacturing Processes, 2021
- Effects of tensile strength on friction welding condition and weld faying surface properties of friction welded joints between pure copper and austenitic stainless steelJournal of Advanced Joining Processes, 2020
- Review on Friction Welding of Similar/Dissimilar MetalsJournal of Physics: Conference Series, 2019
- The research works of Coulomb and Amontons and generalized laws of frictionFriction, 2015
- Comparative analysis of heat generation in friction welding of steel barsActa Materialia, 2008
- Friction welding of dissimilar pure metalsJournal of Materials Processing Technology, 2007
- The significance and use of the friction coefficientTribology International, 2001
- ITER neutral beam systemNuclear Fusion, 2000