Two-Step Plasma Treatment on Sputtered and Electroplated Cu Surfaces for Cu-To-Cu Bonding Application
Open Access
- 28 August 2019
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 9 (17) , 3535
Abstract
The technology trends of next generation electronic packaging are moving toward heterogeneous 3D packaging systems. One of the key processes of 3D packaging system is Cu-to-Cu bonding, which is highly dependent on the planarized, activated, and oxygen-free Cu surface. A two-step plasma treatment is studied to form a Cu surface that does not react with oxygen and improves the Cu bonding interface quality at low bonding temperature (300 °C). In this study, the effects of two-step plasma treatment on both sputtered and electroplated Cu surfaces were evaluated through structural, chemical, and electrical analysis. The Cu bonding interface was studied by scanning acoustic tomography analysis after the thermocompression bonding process. Both sputtered and electroplated Cu thin films had the preferred orientation of (111) plane, but sputtered Cu exhibited larger grains than the electroplated Cu. As a result, the roughness of sputtered Cu was lower, and the resistivity was higher than that of electroplated Cu. Based on X-ray photoelectron spectroscopy analysis, the sputtered Cu formed more copper nitrides and fewer copper oxides than the electroplated Cu. A significant improvement in bonding quality at the Cu bonded interface was observed in sputtered Cu.Keywords
Funding Information
- National Research Foundation of Korea (NRF-2018R1A2B6003921)
- Ministry of Trade, Industry & Energy (#20003524)
This publication has 19 references indexed in Scilit:
- Copper-to-copper direct bonding on highly (111)-oriented nanotwinned copper in no-vacuum ambientScientific Reports, 2018
- Modified pulse laser deposition of Ag nanostructure as intermediate for low temperature Cu-Cu bondingApplied Surface Science, 2018
- Demonstration of sub 150 °C Cu-Cu thermocompression bonding for 3D IC applications, utilizing an ultra-thin layer of Manganin alloy as an effective surface passivation layerMaterials Letters, 2017
- Demonstration and Electrical Performance of Cu–Cu Bonding at 150 °C With Pd PassivationIEEE Transactions on Electron Devices, 2015
- Effects of surface treatment on the bonding quality of wafer-level Cu-to-Cu thermo-compression bonding for 3D integrationJournal of Micromechanics and Microengineering, 2013
- Low temperature CuCu thermo-compression bonding with temporary passivation of self-assembled monolayer and its bond strength enhancementMicroelectronics Reliability, 2012
- Fabrication and characterization of metal-to-metal interconnect structures for 3-D integrationJournal of Instrumentation, 2009
- Calibration of Rent's rule models for three-dimensional integrated circuitsIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 2004
- Room temperature Cu–Cu direct bonding using surface activated bonding methodJournal of Vacuum Science & Technology A, 2003
- Properties of various sputter-deposited Cu–N thin filmsJournal of Vacuum Science & Technology A, 1998