Characterization of bainite-ferrite structures formed on the heat-affected zone of a dissimilar welds of high-strength steel (S700MC/S960QC) and their dependency on cooling time
- 1 January 2020
- journal article
- research article
- Published by Društvo za unapređivanje zavarivanja u Srbiji - DUZS in Zavarivanje i zavarene konstrukcije
- Vol. 65 (4) , 159-172
Abstract
Modern steel structures and joints must satisfy various increasingly demanding requirements such as high yield strength, improved cross section to mass ratio, and desirable ductile-to-brittle transition properties. Consequently, joining different types of high-strength steels has become an attractive option from the cost perspective and for weight and corrosion reduction. In dissimilar welding, however, there remains a need for better understanding of discrepancies in microstructure formation resulting from asymmetric heat distribution. In this study, a characterization of the transformation of bainite, ferrite, and martensite in the microstructure of the heat affected zone (HAZ) formed by a cooling time of 10 kJ/cm of heat input was carried out for dissimilar high-strength joint steels (S700MC/S960QC). The characterization was performed by scan electron microscopy (SEM) sampling, the images of which were analyzed by ImageJ Pro and evaluated by volume fraction of block - like granular bainite (GB). The alloy elements composition close to the fusion line of both materials was then assessed using energy dispersive X-ray spectroscopy (EDS). The results showed a strong presence of GB, which had about 70% volume fraction in S700MC at 615 °C, and which comprised formations of lower bainite and retained austenite (RA) at 420 °C. The presence of 55% block GB was observed at 470 °C in S960QC, which was caused by the formation of tempered martensite (TMA) at 400 °C. Presence of 1.3Ni, 0.4Mo, and 1.6Mn in the coarse grain heat affected zone (CGHAZ) of S700MC confirmed the risk of brittle failure on the S700MC side due to the high presence of carbide and ferrite in the GB.Keywords
This publication has 10 references indexed in Scilit:
- Experimental review of thermal analysis of dissimilar welds of High-Strength SteelREVIEWS ON ADVANCED MATERIALS SCIENCE, 2019
- Simulation of bainite and martensite formation using a novel cellular automata methodProcedia Manufacturing, 2018
- Characterization of bainitic/martensitic structures formed in isothermal treatments below the M s temperatureMaterials Characterization, 2017
- Effect of heat input on dissimilar welds of ultra high strength steel and duplex stainless steel: Microstructural and compositional analysisMaterials Characterization, 2017
- Upcoming Meetings Related to Alzheimer’s DiseaseJournal of Alzheimer’s Disease, 2016
- A Microstructure Evolution Model for Intercritical Annealing of a Low-carbon Dual-phase SteelISIJ International, 2014
- Analysis of Simulated Welding Thermal Cycles S700MC Using Thermal Imaging CameraAdvanced Materials Research, 2013
- The kinetics of bainite and martensite formation in steels during coolingMaterials Science and Engineering: A, 2010
- Characterisation and Quantification of Complex Bainitic Microstructures in High and Ultra-High Strength Linepipe SteelsMaterials Science Forum, 2005
- Microstructure of martensite–austenite constituents in heat affected zones of high strength low alloy steel welds in relation to toughness propertiesScience and Technology of Welding and Joining, 2000