Simulation and experimental study of electro-pneumatic valve used in air-powered engine
- 1 March 2009
- journal article
- Published by Zhejiang University Press in Journal of Zhejiang University-SCIENCE A
- Vol. 10 (3) , 377-383
Abstract
To evaluate the performance of newly designed electro-pneumatic valves (EPVs) for the air-powered engine (APE) and study laws of parameters affecting them, a simulation model was established based on the thermodynamics and mechanics theories. Experiments were set up to determine the instantaneous effective orifice area of solenoid valve by the constant volume discharge method. The simulation model was also validated by comparing the measured displacement curve with the simulated displacement curve of the valve in the pressure of 0.16 and 0.49 MPa. Simulation and experimental results showed that maximum working frequency of the designed EPV could reach 30 Hz corresponding to 2000 r/min of engine rotating speed. Based on simulation results, impacts of temperature and pressure of control air on delay time, full opening/closing time and seating velocity of EPV were analyzed. The simulation model could also act as EPV simulation prototype in designing the air exchange control system of APE.Keywords
This publication has 14 references indexed in Scilit:
- Practicality study on air-powered vehicleFrontiers of Energy and Power Engineering in China, 2008
- Parameter identification for nonlinear pneumatic cylinder actuators2007
- Development of electro-pneumatic fast switching valve and investigation of its characteristicsMechatronics, 2006
- FPGA Controlled Pneumatic Variable Valve ActuationSAE International Journal of Advances and Current Practices in Mobility, 2006
- Simulation on the port timing of an air-powered engineInternational Journal of Vehicle Design, 2005
- Study on Variable Valve Timing System Using Electromagnetic MechanismSAE International Journal of Advances and Current Practices in Mobility, 2004
- Parametric optimization of a new hybrid pneumatic-combustion engine conceptInternational Journal of Engine Research, 2004
- An Investigation Into the Characteristics of a Two Dimensional “2D” Flow Control ValveJournal of Dynamic Systems, Measurement, and Control, 2001
- A High Performance Pneumatic Force Actuator System: Part I—Nonlinear Mathematical ModelJournal of Dynamic Systems, Measurement, and Control, 1999
- Initial Test Results of an Electro-Hydraulic variable-Valve Actuation System on a Firing EngineSAE International Journal of Advances and Current Practices in Mobility, 1989