Experimental Investigation of Factors Affecting Individual Firebrand Heat Transfer
Authors:
- 25 May 2026
- journal article
- Published by ASME International in ASME Journal of Heat and Mass Transfer
- Vol. 148 (8)
Abstract
Firebrand ignition is a significant contributor to the spread of wildfires into communities. This study investigates effects of flow velocity, firebrand wood type and size, and substrate material on the peak heat flux and total heat transfer from individual disk-shaped firebrands. Firebrand heat transfer to a surface is measured with a thin skin calorimeter embedded in the substrate. Peak heat fluxes were between 22 kW/m2 and 84 kW/m2 and were higher for the smaller radius firebrands. The total heating to the substrate also tended to be higher for the smaller radius firebrands, but was about the same for the two substrate materials tested. Notably, flow velocity had almost no impact on peak heat flux, and higher velocities increased the total heating only for some firebrand wood types. Two correlations were determined to predict peak heat flux and total heating based on experimental parameters, which included the measured firebrand temperature. These correlations confirmed the importance of substrate properties on firebrand heat transfer.Keywords
Funding Information
- Engineering Laboratory (5010)
This publication has 23 references indexed in Scilit:
- The Propensity of Wooden Crevices to Smoldering Ignition by FirebrandsFire Technology, 2022
- Spotting ignition of larch (Larix gmelinii) fuel bed by different firebrandsJournal of Forestry Research, 2021
- Effect of firebrand size and geometry on heating from a smoldering pile under windFire Safety Journal, 2021
- Ignition of a spot smolder in a moist fuel bed by a firebrandFire Safety Journal, 2019
- Thermal characterization of firebrand pilesFire Safety Journal, 2019
- Experimental and Analytical Characterization of Firebrand Ignition of Home Insulation MaterialsFire Technology, 2019
- Experimental investigation of firebrand accumulation zones in front of obstaclesFire Safety Journal, 2017
- Smoldering Combustion2016
- On the ignition of fuel beds by firebrandsFire and Materials, 2005
- An improvement on the quraishi‐fahidy method of dimensional analysisThe Canadian Journal of Chemical Engineering, 1988