The impact of heater-recess and load matching in phase change memory mushroom cells
Authors:
- Adam CywarACAdam Cywar
- Jing LiJLJing Li
- Chung LamCLChung Lam
- Helena SilvaHSHelena Silva
- 10 May 2012
- journal article
- Published by IOP Publishing in Nanotechnology
- Vol. 23 (22) , 225201
Abstract
Two-dimensional finite element simulations with rotational symmetry are used to analyze the impact of the bottom electrode recess on the reset operation of phase change memory elements with mushroom cell geometry (Ge2Sb2Te5 (GST) film over a patterned TiN pillar). Temperature dependent materials parameters are used for GST and TiN, and the latent heat of fusion in melting of GST is included to model melting. The results of this study indicate that a lower reset current and a more favorable thermal profile may be achieved by extending the active region of GST down into the pillar, due to the heat confinement. It is shown that the current through cells with an insufficient load condition for maximum power transfer can be maintained at a level lower than that which is sufficient for reset operation for extended periods of time due to the non-linear nature of temperature dependent electrical conductivity of GST. These results suggest that if the load condition is not matched, excessive voltage levels or pulse durations would be necessary to achieve successful reset operation across cell arrays.Keywords
This publication has 11 references indexed in Scilit:
- Modeling of Set and Reset Operations of Phase-Change Memory CellsIEEE Electron Device Letters, 2011
- Phase Change MemoryProceedings of the IEEE, 2010
- Electric Resistivity Measurements of Sb2Te3and Ge2Sb2Te5Melts Using Four-Terminal MethodJapanese Journal of Applied Physics, 2010
- Phase change memory technologyJournal of Vacuum Science & Technology B, 2010
- Thermal and Electrical Characterization of Materials for Phase-Change Memory CellsJournal of Chemical & Engineering Data, 2009
- Phase-change random access memory: A scalable technologyIBM Journal of Research and Development, 2008
- Temperature dependence on the contact size of GeSbTe films for phase change memoriesJournal of Computational Electronics, 2008
- Thermal conductivity of phase-change material Ge2Sb2Te5Applied Physics Letters, 2006
- Three Dimensional Crystallization Simulation and Recording Layer Thickness Effect in Phase Change Optical RecordingJapanese Journal of Applied Physics, 2003
- Rapid-phase transitions of GeTe-Sb2Te3 pseudobinary amorphous thin films for an optical disk memoryJournal of Applied Physics, 1991