Effect of surface treatment on the initial bond strength of different luting cements to zirconium oxide ceramic
Authors:
- 30 August 2008
- journal article
- research article
- Published by Springer Nature in Clinical Oral Investigations
- Vol. 13 (2) , 229-235
Abstract
The objective of this study was to compare the shear bond strength to zirconium oxide ceramic of adhesive-phosphate-monomer-containing (APM) and non-APM-containing (nAPM) luting cements after different surface treatments. nAPM cements: Bifix QM, Dual Cement, Duo Cement Plus, Multilink Automix, ParaCem Universal DC, PermaCem Smartmix, RelyX ARC, Variolink Ultra, and Variolink II; APM cements: Panavia EX, Panavia F2.0, and RelyX UniCem. Groups of ten test specimens were each prepared by layering luting cement, using cylindrical Teflon molds, onto differently treated zirconium dioxide discs. The surface treatments were airborne-particle abrasion with 110 μm alumina particles, silica coating (SC) using 30 μm alumina particles modified by silica (Rocatec System) or SC and silanization. Bifix QM and Multilink Automix were used in combination with an additional bonding/priming agent recommended by the manufacturers. After 48 h of water storage, each specimen was subjected to a shear test. Combinations involving APM-containing cements (14.41–23.88 MPa) generally exhibited higher shear bond strength than those without APM (4.29–17.34 MPa). Exceptions were Bifix QM (14.20–25.11 MPa) and Multilink Automix (19.14–23.09 MPa) in combination with system-specific silane or priming agent, which were on the upper end of shear bond strength values. With the use of the Rocatec system, a partially significant increase in shear bond strength could be achieved in nAPM cement. Modified surface treatment modalities increased the bond strength to zirconium oxide, although the most important factor in achieving a strong bond was the selection of a suitable cement. System-specific priming or bonding agents lead to further improvement.Keywords
This publication has 42 references indexed in Scilit:
- Influence of saliva contamination on zirconia ceramic bondingDental Materials, 2008
- Comparison of resin cement adhesion to Y-TZP ceramic following manufacturers’ instructions of the cements onlyClinical Oral Investigations, 2007
- Evaluation of resin adhesion to zirconia ceramic using some organosilanesDental Materials, 2006
- Fracture strength of two oxide ceramic crown systems after cyclic pre‐loading and thermocyclingJournal of Oral Rehabilitation, 2006
- Effect of thermocycling on bond strength of luting cements to zirconia ceramicDental Materials, 2006
- Bonding of dual‐cured resin cement to zirconia ceramic using phosphate acid ester monomer and zirconate couplerJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2005
- Bond strength of a new universal self-adhesive resin luting cement to dentin and enamelClinical Oral Investigations, 2005
- All‐ceramic fixed partial dentures designed according to the DC‐Zirkon® technique. A 2‐year clinical studyJournal of Oral Rehabilitation, 2005
- Shear bond strength of resin bonded ceramic after different try-in proceduresJournal of Dentistry, 1994
- Tensile bond of resin cements to porcelain veneersThe Journal of Prosthetic Dentistry, 1988