A Method of Comparative Evaluation of the Drive Units of Two Bucket Elevators—A Case Study
Open Access
Abstract
Bucket elevators are applied in many industries for bulk material handling. One of the main requirements for these devices is their high operational reliability. This applies in particular to power units that must operate continuously without failure. This article presents a comparative assessment of the drive units of two bucket elevators. The vibration intensity of their bearing units was used as the basis for the comparison. The evaluation was carried out using three independent methods based on the vibration velocity analysis: in the time domain, in the frequency domain and using the probabilistic approach.Keywords
This publication has 22 references indexed in Scilit:
- Comparative measurements of ground penetrating radars used for road and bridge diagnostics in the Czech Republic and FranceConstruction and Building Materials, 2017
- Identification and classification of failure modes in laminated composites by using a multivariate statistical analysis of wavelet coefficientsMechanical Systems and Signal Processing, 2017
- The influence of superstructure vibrations on operational loads in the undercarriage of bulk material handling machineArchives of Civil and Mechanical Engineering, 2017
- Fault detection enhancement in wind turbine planetary gearbox via stationary vibration waveform dataJournal of Low Frequency Noise, Vibration and Active Control, 2017
- A review on signal processing techniques utilized in the fault diagnosis of rolling element bearingsTribology International, 2016
- Wavelets for fault diagnosis of rotary machines: A review with applicationsSignal Processing, 2014
- Hilbert transform in vibration analysisMechanical Systems and Signal Processing, 2011
- A comparative experimental study on the diagnostic and prognostic capabilities of acoustics emission, vibration and spectrometric oil analysis for spur gearsMechanical Systems and Signal Processing, 2007
- A review on machinery diagnostics and prognostics implementing condition-based maintenanceMechanical Systems and Signal Processing, 2006
- Fundamentals of vibroacoustical condition monitoring1998