Influence of the reactor wall composition on radicals’ densities and total pressure in Cl2 inductively coupled plasmas: II. During silicon etching
Authors:
- 1 November 2007
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 102 (9) , 093305
Abstract
In an industrial inductively coupled plasma reactor dedicated to silicon etching in chlorine-based chemistry, the density of molecules and the gas temperature are measured by means of laser absorption techniques, the density of radicals by broadband absorption spectroscopy, the density of and ions by mass spectrometry, and the total gas pressure with a capacitance gauge. These measurements permit us to estimate the mole fractions of Cl, , and etch product radicals when etching a diameter silicon wafer. The pure plasma is operated in well prepared chamber wall coating with a thin film of SiOCl, AlF, CCl, or TiOCl. The impact of the chemical nature of the reactor wall’s coatings on these mole fractions is studied systematically. We show that the reactor wall coatings have a huge influence on the radicals densities, but this is not only from the difference on Cl–Cl recombination coefficient on different surfaces. During silicon etching, radicals sticking on the reactor walls are etched by Cl atoms and recycled into the plasma by forming volatile . Hence, the loss of Cl atoms in etching the wall deposited silicon is at least as important as their wall recombination in controlling the Cl atoms density. Furthermore, because is produced at high rate by both the wafer and reactor walls, it is the predominant etching product in the gas phase. However, the percentage of redeposited silicon that can be recycled into the plasma depends on the amount of oxygen present in the plasma: O atoms produced by etching the quartz roof window fix Si on the reactor walls by forming a SiOCl deposit. Hence, the higher the O density is, the lower the density will be, because silicon is pumped by the reactor walls and the SiOCl layer formed is not isotropically etched by chlorine. As a result, in the same pure plasma at , the mole fraction can vary from 18% in a SiOCl-coated reactor, where the O density is the highest, to 62% in a carbon-coated reactor, where there is no O. In the latter case, most of the Cl mass injected in the reactor is stored in molecules, which results in a low silicon etch rate. In this condition, the Cl mass balance is verified within 10%, and from the silicon mass balance we concluded that radicals have a high surface loss probability. The impact of the reactor wall coating on the etching process is thus important, but the mechanisms by which the walls control the plasma chemistry is much more complicated than a simple control through recombination reaction of halogen atoms on these surfaces.
Keywords
This publication has 37 references indexed in Scilit:
- Is actinometry reliable for monitoring Si and silicone halides produced in silicon etching plasmas? A comparison with their absolute densities measured by UV broad band absorptionThe European Physical Journal Applied Physics, 2006
- Plasma etching of high dielectric constant materials on silicon in halogen chemistriesJournal of Vacuum Science & Technology A, 2003
- Temperature-dependent Cl2/Ar plasma etching of bulk single-crystal ZnOApplied Physics Letters, 2003
- Plasma etching of AlN/AlGaInN superlattices for device fabricationApplied Physics Letters, 2002
- Percent dissociation of Cl2 in inductively coupled, chlorine-containing plasmasJournal of Applied Physics, 1998
- Absolute concentration measurements by pulsed laser-induced fluorescence in low-pressure gases: allowing for saturation effectsChemical Physics Letters, 1996
- A simple optical emission method for measuring percent dissociations of feed gases in plasmas: Application to Cl2 in a high-density helical resonator plasmaJournal of Vacuum Science & Technology A, 1996
- Pulse-time-modulated electron cyclotron resonance plasma etching with low radio-frequency substrate biasApplied Physics Letters, 1996
- Measurements of the Cl atom concentration in radio-frequency and microwave plasmas by two-photon laser-induced fluorescence: Relation to the etching of SiJournal of Vacuum Science & Technology A, 1992
- Atomic chlorine concentration measurements in a plasma etching reactor. I. A comparison of infrared absorption and optical emission actinometryJournal of Applied Physics, 1987