Characterization of the anisotropic etching of silicon in two-component alkaline solution
Open Access
- 22 August 2007
- journal article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 17 (9) , 1916-1922
Abstract
The characteristics of wet chemical etching processes were compared for crystalline Si in aqueous solutions of pure NaOH and NaOH with added oxidizing agent NaOCl (sodium-hypochlorite). Due to the addition of NaOCl to the reference NaOH solution, the etch rate decreased for the {1?0?0} and {1?1?0} planes and increased for the {1?1?1} plane. The difference between the activation energy of these etching processes for the three different crystallographic directions became rather small due to the combined effect of the oxidation and the subsequent etching sub-processes. This means that the temperature dependence of the number of kinks as chemical oxidation sites is very similar for the different planes. For the {1?1?1} plane the oxidation sub-process has a higher efficiency resulting in an increased etch rate whereas the etch rate decays for the {1?0?0} and {1?1?0} planes due to enhanced passivation, and these two phenomena contribute to the decrease of the anisotropy. Due to the addition of NaOCl, the oxidation sub-process is more isotropic but still site dependent. In the practice, the etched surface remains of good quality without defect development. In the presence of the oxidizing agent, the difference of the etch rates in the 1?0?0 and 1?1?0 directions is reversed to R100 < R110. This fact can be exploited in the formation of novel 3D structures on the (1?0?0) wafers by forming a square-masking pattern aligned precisely to the 1?0?0 directions.Keywords
This publication has 15 references indexed in Scilit:
- Three-dimensional force sensor by novel alkaline etching techniqueSensors and Actuators A: Physical, 2005
- Novel low cost chemical texturing for very large area industrial multi-crystalline silicon solar cellsSemiconductor Science and Technology, 2005
- Anisotropic etching of silicon in a two-component alkaline solutionJournal of Micromechanics and Microengineering, 2002
- Measuring the Site-Specific Reactivity of Impurities: The Pronounced Effect of Dissolved Oxygen on Silicon EtchingThe Journal of Physical Chemistry B, 2002
- Influence of the angle between etched (near) Si{ 111} surfaces and the substrate orientation on the underetch rate during anisotropic wet-chemical etching of siliconJournal of Micromechanics and Microengineering, 2001
- Porous silicon formation by stain etchingThin Solid Films, 2001
- Optimization of a low-stress silicon nitride process for surface-micromachining applicationsSensors and Actuators A: Physical, 1997
- Etching of Silicon in NaOH Solutions: II . Electrochemical Studies of n‐Si(111) and (100) and Mechanism of the DissolutionJournal of the Electrochemical Society, 1993
- 45% efficient silicon photovoltaic cell under monochromatic lightIEEE Electron Device Letters, 1992
- Anisotropic Etching of Crystalline Silicon in Alkaline Solutions: I . Orientation Dependence and Behavior of Passivation LayersJournal of the Electrochemical Society, 1990