Towards Standardising SHPB Testing - A Round Robin Exercise
Open Access
- 7 September 2018
- journal article
- research article
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 183, 02027
Abstract
The Split Hopkinson Pressure Bar (SHPB) test, while widely utilised for high strain rate tests, has yet to be standardised. As an exploratory step towards developing a standard test method or protocol, a Round Robin test series has been conducted between four institutions: (i) Swinburne University of Technology, Australia (ii) University of São Paulo, Brazil, (iii) University of Cape Town, South African and (iv) Nanyang Technological University, Singapore. Each institution prepared specimens from a metallic material, and provided batches of specimens from their chosen material to the other institutions. The materials utilised in this round of testing were commercially pure copper and aluminium, magnesium alloy and stainless steel (316 grade). The intent of the first exercise is to establish the consistency of SHPB test results on nominally identical specimens at comparable elevated strain rates, conducted by different laboratories following notionally similar test procedures with some freedom in data processing. This paper presents and compares the results of the first batch of tests for copper, identifying variations between results from different laboratories. The variation between different laboratories’ results for copper is suffciently small that there is confidence in the potential to develop a draft standard in future.Keywords
This publication has 9 references indexed in Scilit:
- Misalignment effect in the split Hopkinson pressure bar techniqueInternational Journal of Impact Engineering, 2012
- Split Hopkinson (Kolsky) Bar2011
- Classic Split-Hopkinson Pressure Bar Testing2000
- Determination of the dynamic response of brittle composites by the use of the split Hopkinson pressure barComposites Science and Technology, 1999
- On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strainsInternational Journal of Solids and Structures, 1996
- A numerical method for the correction of dispersion in pressure bar signalsJournal of Physics E: Scientific Instruments, 1983
- Wave Propagation in the Split Hopkinson Pressure BarJournal of Engineering Materials and Technology, 1983
- An Investigation of the Mechanical Properties of Materials at very High Rates of LoadingProceedings of the Physical Society. Section B, 1949
- A critical study of the Hopkinson pressure barPhilosophical Transactions of the Royal Society of London. Series A, Mathematical and Physical Sciences, 1948