A Sub-μW Energy-Performance-Aware IoT SoC With a Triple-Mode Power Management Unit for System Performance Scaling, Fast DVFS, and Energy Minimization
- 19 January 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 59 (7) , 2272-2285
Abstract
This article presents an ultra-low-power (ULP) Internet-of-Things (IoT) system-on-chip (SoC) using a triple-mode power management unit (PMU) to achieve self-adaptive power–performance scaling and energy-minimized operation. The proposed PMU comprises three modes: energy-aware (EA) mode, performance-aware (PA) mode, and minimum energy point (MEP) tracking mode. By controlling a microprocessor with the three modes, the SoC can adaptively scale its frequency and supply voltage based on either the input energy availability or the task priority. To achieve robust and rapid mode transitions, the SoC adopts fast dynamic voltage and frequency scaling (DVFS) and fast load transient response (FLTR) through asynchronous control. For energy-minimized operation, a sub-nW constant-energy-cycle (CEC) algorithm keeps the microprocessor operating at the MEP with a 0.026-mm $^{2}$ area overhead. In addition, the on-chip integration of a bias generator (BG), clock (CLK), and power-on-reset block empowers the SoC to be a fully self-contained system. Fabricated in 65-nm CMOS, measurement results show that the SoC has a minimum power consumption of 194.3 nW at 180 Hz. The proposed PMU achieves 5.2-nW quiescent power and 92.6% peak efficiency while maintaining $>$ 80% efficiency from 190 nW to 3 mW. The MEP tracking (MEPT) circuits achieve $<$ 2.3% energy per cycle error and $<$ 18 mV voltage tracking error. The measured quiescent power of the MEPT circuits in the idle mode is 379 pW, which only accounts for 0.19% of the total system power. Measurements of the triple-mode transitions show that this SoC is well suited for resource-constrained IoT applications.Keywords
Funding Information
- U.S. Department of Energy’s Office of Energy Efficiency and Renewable Energy (DE-EE0008225)
- NSF Nanosystems Engineering Research Center (NERC) Advanced Self-Powered Systems of Integrated Sensors and Technologies (ASSIST) Center (EEC-1160483)
This publication has 24 references indexed in Scilit:
- Sub-nW Microcontroller With Dual-Mode Logic and Self-Startup for Battery-Indifferent Sensor NodesIEEE Journal of Solid-State Circuits, 2020
- Integrated Power Management for Battery-Indifferent Systems With Ultra-Wide Adaptation Down to nWIEEE Journal of Solid-State Circuits, 2019
- A Self-Tuning IoT Processor Using Leakage-Ratio Measurement for Energy-Optimal OperationIEEE Journal of Solid-State Circuits, 2019
- A Unified Clock and Switched-Capacitor-Based Power Delivery Architecture for Variation Tolerance in Low-Voltage SoC DomainsIEEE Journal of Solid-State Circuits, 2019
- An Energy-Efficient Graphics Processor in 14-nm Tri-Gate CMOS Featuring Integrated Voltage Regulators for Fine-Grain DVFS, Retentive Sleep, and ${V}_{\text{MIN}}$ OptimizationIEEE Journal of Solid-State Circuits, 2018
- A High-Frequency Three-Level Buck Converter With Real-Time Calibration and Wide Output Range for Fast-DVSIEEE Journal of Solid-State Circuits, 2017
- A 20-pW Discontinuous Switched-Capacitor Energy Harvester for Smart Sensor ApplicationsIEEE Journal of Solid-State Circuits, 2017
- Noise-aware simulation-based sizing and optimization of clocked comparatorsAnalog Integrated Circuits and Signal Processing, 2014
- Minimum Energy Tracking Loop With Embedded DC–DC Converter Enabling Ultra-Low-Voltage Operation Down to 250 mV in 65 nm CMOSIEEE Journal of Solid-State Circuits, 2008
- Modeling and sizing for minimum energy operation in subthreshold circuitsIEEE Journal of Solid-State Circuits, 2005