Numerical comparison of two-phase flow characteristics for different nozzle designs in double-sided blowing furnaces
- 1 October 2025
- journal article
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (10)
Abstract
To investigate the influence of nozzle design on the homogeneity of mixing and smelting efficiency within a double-sided blowing furnace during the smelting process, a computational fluid dynamics simulation was carried out using the volume of fluid model, and the realizable turbulence k-ε model to simulate the liquid flow within the furnace. Analysis of furnace velocity distribution across operating conditions revealed that penetration depth variations correlated with bubble generation, bubble growth, bubble rise, and bubble breakage. To optimize molten pool mixing efficiency, four nozzle configurations were proposed: (1) cone straight shape; (2) excessive rounded corners; (3) conical; (4) anti-conical. Among these improved nozzle types, the conical nozzle demonstrated the best improvement effect. Compared to the ordinary nozzle, the dead zone proportion decreased by 16.57% and the penetration depth increased by 57.28%. Furthermore, this study also proposes combining nozzle types with distribution patterns. The relative conical mode stands out, showing an average velocity increase in 117.37%, a 37.17% reduction in dead zone proportion, and a 45.06% decrease in splash mass, compared to the ordinary nozzle.Keywords
Funding Information
- National Natural Science Foundation of China (51904069)
- Natural Science Foundation of Hebei Province (E2025501002)
- Fundamental Research Funds for the Central Universities (2025GFYD001)
This publication has 14 references indexed in Scilit:
- Numerical simulation of jet break-up in the second-wind induced regime using the local front reconstruction methodChemical Engineering Science, 2024
- Multiphase Stirring Dynamics of Gas-Slag-Matte in Large-Scale Side-Blown Copper Bath Smelting ProcessJournal of Sustainable Metallurgy, 2024
- Numerical Simulation and Optimization Analysis of Primary Air Injection Mode in Oxygen-Rich Side-Blown Bath Smelting FurnaceJournal of Sustainable Metallurgy, 2023
- Flow zone distribution and mixing time in a Peirce—Smith copper converterInternational Journal of Minerals, Metallurgy and Materials, 2021
- Computational Fluid Dynamics Study on Enhanced Circulation Flow in a Side-Blown Copper Smelting FurnaceJOM, 2021
- Experimental Study on Bubble Distribution and Splashing in a Peirce–Smith Copper ConverterMetallurgical and Materials Transactions B, 2021
- Oxygen-Rich Side-Blown Bath Smelting of Copper Dross: A Process StudyJournal of Sustainable Metallurgy, 2020
- Induced mixing in stratified fluids by rising bubbles in a thin gapPhysical Review Fluids, 2020
- Experiment and numerical simulation of two-phase flow in oxygen enriched side-blown furnaceTransactions of Nonferrous Metals Society of China, 2020
- A Water Model Study on Mixing Behavior of the Two-Layered Bath in Bottom Blown Copper Smelting FurnaceJOM, 2018