Micro-Optical Waveguides Realization by Low-Cost Technologies
Open Access
Abstract
Microscale optofluidic devices are a category of microscale devices combining fluidic and optical features. These devices typically enable in-situ fluid flow measurement for pharmaceutical, environmental or biomedical applications. In micro-optofluidic devices, in order to deliver, as close as possible, the input light to the sample or a specific chip section and, collect the output signal, it is necessary to miniaturize optical components. In this paper, two low-cost technologies, 3D Printing PDMS-based and laser cutting PMMA-based (PDMS stands for Poly-dimethyl-siloxane and PMMA for Poly-methyl-methacrylate), were investigated as novel methods to realize micro-optical waveguides () comparing their performances. An ad-hoc master-slave protocol developed to realize PDMS components by 3D Printing has been fully optimized. The manufacturing technologies proposed require simple and low-cost equipment and no strictly controlled environment. Similar results are obtained for both the micro-optical waveguides realized. Their losses, disregarding the losses caused by the fibers’ alignment and the miss-match of the geometry with the waveguide, are of the order of , almost equivalent for both approaches (PDMS- and PMMA-). The losses are of the order of when the PDMS- is shielded by a copper layer, with a significant improvement of the signal acquired. The results obtained show the possibility of using the two low-cost technologies presented for the realization of micro-optical waveguides suitable to be integrated in micro-optofluidic devices and the potential of creating micro-optical paths inside micro-embedded systems.
Keywords
Funding Information
- Università di Catania (Grant Scheme PIACERI)
This publication has 49 references indexed in Scilit:
- A polymeric micro-optical system for the spatial monitoring in two-phase microfluidicsMicrofluidics and Nanofluidics, 2011
- Minute particle detection using a light-wave-guide incorporated optical total analysis systemMicrosystem Technologies, 2011
- A polymeric micro-optical interface for flow monitoring in biomicrofluidicsBiomicrofluidics, 2010
- Fast replication of out-of-plane microlens with polydimethylsiloxane and curable polymer (NOA73)Microsystem Technologies, 2010
- The origins and the future of microfluidicsNature, 2006
- Study of reactive ion etching process to fabricate the PMMA-based polymer waveguideMicroelectronics Journal, 2004
- UV written waveguides using crosslinkable PMMA-based copolymersOptical Materials, 2003
- PDMS 2D optical lens integrated with microfluidic channels: principle and characterizationLab on a Chip, 2003
- CO2-laser micromachining and back-end processing for rapid production of PMMA-based microfluidic systemsLab on a Chip, 2002
- Polymer microfluidic devicesTalanta, 2002