Electrochemical Performances of Li-Ion Batteries Based on LiFePO4 Cathodes Supported by Bio-Sourced Activated Carbon from Millet Cob (MC) and Water Hyacinth (WH)
Open Access
- 30 September 2025
- Vol. 11 (10) , 361
Abstract
The electrochemical performance of Li-ion batteries employing LiFePO4 (LFP) cathodes supported by bio-sourced activated carbon derived from millet cob (MC) and water hyacinth (WH) were systematically investigated. Carbon activation was carried out using potassium hydroxide (KOH) at varying mass ratios of KOH to precursor material: 1:1, 2:1, and 5:1 for both WH and MC-derived carbon. The physical properties (X-ray diffraction patterns, BET surface area, micropore and mesopore volume, conductivity, etc.) and electrochemical performance (specific capacity, discharge at various current rates, electrochemical impedance measurement, etc.) were determined. Material characterization revealed that the activated carbon derived from MC exhibits an amorphous structure, whereas that obtained from WH is predominantly crystalline. High specific surface areas were achieved with activated carbons synthesized using a low KOH-to-carbon mass ratio (1:1), reaching 413.03 m2·g−1 for WH and 216.34 m2·g−1 for MC. However, larger average pore diameters were observed at higher activation ratios (5:1), measuring 8.38 nm for KOH/WH and 5.28 nm for KOH/MC. For both biomass-derived carbons, optimal electrical conductivity was obtained at a 2:1 activation ratio, with values of 14.7 × 10−3 S·cm−1 for KOH/WH and 8.42 × 10−3 S·cm−1 for KOH/MC. The electrochemical performance of coin cells based on cathodes composed of 85% LiFePO4, 8% of these activated carbons, and 7% polyvinylidene fluoride (PVDF) as a binder, with lithium metal as the anode were studied. The LiFePO4/C (LFP/C) cathodes exhibited specific capacities of up to 160 mAh·g−1 at a current rate of C/12 and 110 mAh·g−1 at 5C. Both LFP/MC and LFP/WH cathodes exhibit optimal energy density at specific values of pore size, pore volume, charge transfer resistance (Rct), and diffusion coefficient (DLi), reflecting a favorable balance between ionic transport, accessible surface area, and charge conduction. Maximum energy densities relative to active mass were recorded at 544 mWh·g−1 for LFP/MC 2:1, 554 mWh·g−1 for LFP/WH 2:1, and 568 mWh·g−1 for the reference LFP/graphite system. These performance results demonstrate that the development of high-performing bio-sourced activated carbon depends on the optimization of various parameters, including chemical composition, specific surface area, pore volume and size distribution, as well as electrical conductivity.Keywords
All Related Versions
Funding Information
- National Science and Engineering Research Council of Canada (RGP20002705)
- UNESCO Chair (FRQ-CUN-338927)
This publication has 75 references indexed in Scilit:
- Advances in Carbon Nanotubes and Carbon Coatings as Conductive Networks in Silicon‐based AnodesAdvanced Functional Materials, 2024
- Improved electrochemical performance of LiFePO4/carbon cathode for lithium-ion batteriesIonics, 2022
- Green synthesis of ZnO NPs using Pontederia crassipes leaf extract: characterization, their adsorption behavior and anti-cancer propertyBiomass Conversion and Biorefinery, 2022
- Improvement of electrochemical and electrical properties of LiFePO 4 coated with citric acidRare Metals, 2015
- Comparative Study of Electrical Conductivity on Activated Carbons Prepared from Various Cellulose MaterialsArabian Journal for Science and Engineering, 2014
- Synthesis and characterization of Pt-doped LiFePO4/C composites using the sol–gel method as the cathode material in lithium-ion batteriesJournal of Applied Electrochemistry, 2014
- Developments of lithium-ion batteries and challenges of LiFePO4 as one promising cathode materialJournal of Materials Science, 2009
- The Design of a LiFePO4/Carbon Nanocomposite With a Core–Shell Structure and Its Synthesis by an In Situ Polymerization Restriction MethodAngewandte Chemie International Edition, 2008
- Impact of carbon structure and morphology on the electrochemical performance of LiFePO4/C compositesJournal of Solid State Electrochemistry, 2007
- Curvature and parametric sensitivity in models for adsorption in microporesAIChE Journal, 1991