DC-Link Single-Phase to Single-Phase Full-Bridge Converter Operating with Reduced AC Capacitor Voltage
- 1 February 2007
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE) in APEC 07 - Twenty-Second Annual IEEE Applied Power Electronics Conference and Exposition
- No. 10482334,p. 1695-1700
Abstract
This paper proposes a control technique to reduce the ac capacitor voltage of the single-phase full-bridge converter. The reduction of the ac capacitor voltage enable to reduce the capacitor size. The technique can be used for applications where the load frequency is equal to the input frequency. Experimental and simulated results are presented.Keywords
This publication has 8 references indexed in Scilit:
- PWM regenerative rectifiers: state of the artIEEE Transactions on Industrial Electronics, 2005
- An optimized single-phase AC power supply with DC bus synchronization2002
- A novel high-performance voltage regulator for single-phase AC sourcesIEEE Transactions on Industrial Electronics, 2001
- Digital scalar pulse-width modulation: a simple approach to introduce nonsinusoidal modulating waveformsIEEE Transactions on Power Electronics, 2001
- Adaptive SVM to compensate DC-link voltage ripple for four-switch three-phase voltage-source invertersIEEE Transactions on Power Electronics, 1999
- Development of a high-efficiency flywheel UPS using a 3-arm inverter/converterElectrical Engineering in Japan, 1997
- Pulsewidth modulation for electronic power conversionProceedings of the IEEE, 1994
- A new single-phase to three-phase converter with active input current shaping for low cost AC motor drivesIEEE Transactions on Industry Applications, 1993