Mathematical modeling for turning on AISI 420 stainless steel using surface response methodology
- 24 April 2014
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 229 (1) , 45-61
Abstract
In this study, an attempt has been made to statistically model the relationship between cutting parameters (speed, feed rate and depth of cut), cutting force components ( Fx, Fy and Fz) and workpiece absolute surface roughness ( Ra). The machining case of a martensitic stainless steel (AISI 420) is considered in a common turning process by means of a chemical vapor deposition–coated carbide tool. A full-factorial design (43) is adopted in order to analyze obtained experimental results via both analysis of variance and response surface methodology techniques. The optimum cutting conditions are achieved using mutually response surface methodology and desirability function approaches while the model adequacy is checked from residual values. The results indicated that the depth of cut is the dominant factor affecting ( Fx: 86%, Fy: 58% and Fz: 81%), whereas feed rate is found to be the utmost factor influencing surface roughness behavior ( Ra: 81%). In addition, a good agreement between the predicted and measured cutting force components and surface roughness was observed. The results are also validated experimentally by determining errors ( Fx: 6.51%, Fy: 4.36%, Fz: 3.59% and Ra: 5.12%). Finally, the ranges for optimal cutting conditions are projected for serial industrial production.Keywords
This publication has 33 references indexed in Scilit:
- Effect of work material hardness and cutting parameters on performance of coated carbide tool when turning hardened steel: An optimization approachMeasurement, 2013
- Statistical analysis of surface roughness and cutting forces using response surface methodology in hard turning of AISI 52100 bearing steel with CBN toolInternational Journal of Refractory Metals and Hard Materials, 2010
- Determining the influence of cutting fluids on tool wear and surface roughness during turning of AISI 304 austenitic stainless steelJournal of Materials Processing Technology, 2009
- Experimental investigations of cutting parameters influence on cutting forces and surface roughness in finish hard turning of MDN250 steelJournal of Materials Processing Technology, 2008
- Investigations into the effect of cutting conditions on surface roughness in turning of free machining steel by ANN modelsJournal of Materials Processing Technology, 2008
- Analysis of surface roughness parameters in turning of FRP tubes by PCD toolJournal of Materials Processing Technology, 2008
- Tool wear and machining performance of cBN–TiN coated carbide inserts and PCBN compact inserts in turning AISI 4340 hardened steelJournal of Materials Processing Technology, 2006
- On machining of hardened AISI D2 steel with PCBN toolsJournal of Materials Processing Technology, 2006
- Surface roughness model for machining mild steel with coated carbide toolMaterials & Design (1980-2015), 2005
- A note on the determination of optimal cutting conditions for surface finish obtained in turning using design of experimentsJournal of Materials Processing Technology, 2001