Development of a 1550 nm LiDAR System Using Galvanometer and i-ToF Method for Distance Measurement and 2D Object Reconstruction
Open Access
- 30 September 2025
- journal article
- Published by Electrical Engineering Department, Faculty of Engineering, Universitas Indonesia in International Journal of Electrical, Computer, and Biomedical Engineering
- Vol. 3 (3) , 567–578
Abstract
LiDAR (Light Detection and Ranging) is a high-precision distance measurement technology based on laser light reflection. This study develops a galvanometer-based LiDAR system utilizing the indirect Time of Flight (i-ToF) method with 100 MHz sinusoidal modulation and a 1550 nm eye-safe laser diode. The system is designed to measure distance and identify the shape of 2D objects. The system was tested through phase difference measurements, galvanometer response, and flat-surface mapping at distances of 25 cm and 35 cm. The measurement results demonstrate high linearity and stability up to a maximum range of 1.5 meters, in accordance with the 360° phase difference (∆φ) limitation. The measurements of object dimensions in the form of an aluminum foil-covered plate at distances of 25 cm (1.76 cm × 2.63 cm) and 35 cm (2.45 cm × 3.66 cm) indicate that increasing the distance between the object and the system results in a wider coverage area but with reduced spatial resolution. At a distance of 25 cm, the light beam shifts by 0.436 cm/1°∆φ, whereas at 35 cm it shifts by 0.611 cm/1°∆φ. Furthermore, the limited active area of the photodetector was identified as the main factor restricting the detection coverage. This research opens opportunities for further development, particularly in optimizing galvanometer angle adjustments and enhancing the photodetector’s active area to expand coverage and improve measurement accuracy under various operating conditions.Keywords
This publication has 11 references indexed in Scilit:
- Drone LiDAR Occlusion Analysis and Simulation from Retrieved Pathways to Improve Ground Mapping of Forested EnvironmentsDrones, 2025
- Assessment of LiDAR-Based Sensing Technologies in Bird–Drone Collision ScenariosDrones, 2024
- A Low-Power i-ToF LiDAR With Nonlinearity Self-Calibration TechniqueIEEE Transactions on Instrumentation and Measurement, 2023
- Automotive LiDAR Technology: A SurveyIEEE Transactions on Intelligent Transportation Systems, 2021
- A Survey on LiDAR Scanning MechanismsElectronics, 2020
- Lidar remote sensing of the aquatic environment: invitedApplied Optics, 2020
- An Overview of Lidar Imaging Systems for Autonomous VehiclesApplied Sciences, 2019
- Placement Optimization of Multiple Lidar Sensors for Autonomous VehiclesIEEE Transactions on Intelligent Transportation Systems, 2019
- On the Feasibility of Water Surface Mapping with Single Photon LiDARISPRS International Journal of Geo-Information, 2019
- Comparison of 905 nm and 1550 nm semiconductor laser rangefinders’ performance deterioration due to adverse environmental conditionsOpto-Electronics Review, 2014