Comparison of the Shear Bond Strength of Orthodontic Brackets in Bonding and Rebonding: Preparation with Laser Versus Conventional Acid Etch Technique
Authors:
- 1 August 2013
- journal article
- research article
- Published by SAGE Publications in Photomedicine and Laser Surgery
- Vol. 31 (8) , 360-364
Abstract
Objective: The purpose of this study was to compare the bond strength of orthodontic brackets using laser versus acid etching. Background data: Debonding of brackets is a common problem in orthodontic treatments. Materials and methods: Eighty extracted premolar teeth were divided into two groups. The enamel of the teeth in group A and B were etched using CO 2 laser and phosphoric acid, respectively. The brackets were bonded to the teeth using Transbond XT and then debonded from the teeth by Instron machine. The remaining composite on the tooth surface was removed by a tungsten carbide polishing bur. Both groups were divided into two subgroups (A 1 , A 2 and B 1 , B 2 ). The teeth were prepared again with laser in A 1 , B 1 subgroups and with acid in A 2 , B 2 subgroups. At each stage, the shear bond strength and residual adhesive index were measured. One way ANOVA and χ 2 tests were used to analyze data. Results: The mean shear bond strength was significantly lower in group A and higher in group B compared with all other groups ( p< 0.05). Most of the bond failures were degree 0 and 1 in groups A, A 1 , and B 1 , and degree 2 and 3 in groups B, A 2 , and B 2 . Conclusions: Primary preparation with acid has a higher bond strength value than does CO 2 laser. Less adhesive residue remained on enamel after tooth preparation with laser following debonding. Secondary preparation of the enamel using laser has higher bond strength value than does primary preparation with laser, which can rationalize use of laser in rebonding of brackets.Keywords
This publication has 21 references indexed in Scilit:
- Physical and Compositional Changes on Demineralized Primary Enamel Induced by CO 2 LaserPhotomedicine and Laser Surgery, 2009
- Pulpal effects of enamel ablation with a microsecond pulsed λ = 9.3‐µm CO2 laserLasers in Surgery and Medicine, 2009
- Laser etching of enamel for direct bonding with an Er,Cr:YSGG hydrokinetic laser systemAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2002
- The effect of repeated bonding on the shear bond strength of different orthodontic adhesivesAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2002
- Conditioning of enamel with Nd:YAG and CO2 dental laser systems and with phosphoric acid. An in-vitro comparison of the tensile bond strength and the morphology of the enamel surface.Journal of Orofacial Orthopedics / Fortschritte der Kieferorthopädie, 2001
- Sealant bond strengths of CO2 laser-etched versus acid-etched bovine enamelLasers in Surgery and Medicine, 2000
- Super pulse CO2 laser for bracket bonding and debondingEuropean Journal of Orthodontics, 1999
- Effect of tooth-related factors on the shear bond strengths obtained with CO2laser conditioning of enamelAustralian Dental Journal, 1997
- A clinical trial comparing the failure rates of directly bonded brackets using etch times of 15 or 60 secondsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1988
- Clinical trials with crystal growth conditioning as an alternative to acid-etch enamel pretreatmentAmerican Journal of Orthodontics, 1984