Simulation analysis of transformer oil and glycerin as dielectric medium in inductive voltage adders
- 25 August 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Dielectrics and Electrical Insulation
- Vol. 21 (4) , 1778-1783
Abstract
This paper gives the initial consideration of using glycerin medium to substitute the transformer oil widely used in present cells of magnetically insulated inductive voltage adders (MIVA). The effects of different mediums on MIVA performances such as electric field distribution, feed current uniformity, and cell output voltage, are simulated and compared. The simulation results indicate that, in case of four pulses driving simultaneously, the cells insulated by glycerin would output a pulse with the peak voltage increasing by about 8%. However, in case of four pulses driving separately, as replacing transformer oil with glycerin, the peak voltage of cell outputs decreases by 9%, and risetime increases dramatically from 32 ns to 59 ns. For the encountered issues caused by the glycerin medium, some solution methods are presented, and the feasibility of utilizing glycerin in MIVA cells is discussed.Keywords
This publication has 11 references indexed in Scilit:
- Optimized Design of Azimuthal Transmission Lines for the Cell Driven by Two PFLs in Induction Voltage AddersIEEE Transactions on Plasma Science, 2013
- Status of the AWE Hydrus IVA fabrication2011
- Performance of the hermes-III gamma ray simulator2005
- Status of the 10 MV, 120 kA RITS-6 Inductive Voltage Adder2005
- Improved design of a high-voltage vacuum-insulator interfacePhysical Review Special Topics - Accelerators and Beams, 2005
- Induction voltage adder architectures and electrical characteristics2004
- Two and three-dimensional MITL, power-flow studies on RITS2004
- Induction voltage adders and the induction accelerator familyPhysical Review Special Topics - Accelerators and Beams, 2004
- Magnetic Insulation, Power Flow, and Pulse Power Results on RITS-3AIP Conference Proceedings, 2002
- Design of a radiographic integrated test stand (RITS) based on a voltage adder, to drive a diode immersed in a high magnetic fieldIEEE Transactions on Plasma Science, 2000